Winter rebuild Saris racing
09-10-2024 | 10:57 AM
#11
Thread Starter
Registered
Joined: Oct 2000
Posts: 3,815
Likes: 678
From: Lakewood, NY, USA
Padraig
Last edited by Padraig; 09-10-2024 at 10:59 AM.
09-10-2024 | 11:01 AM
#12
Thread Starter
Registered
Joined: Oct 2000
Posts: 3,815
Likes: 678
From: Lakewood, NY, USA
Padraig
09-28-2024 | 01:52 PM
#13
Thread Starter
Registered
Joined: Oct 2000
Posts: 3,815
Likes: 678
From: Lakewood, NY, USA
Trailer has been readied and looked over, including wheel bearings. Took the VR 1 off the lift, went for a run and then put it on trailer. All set for the 6 hour drive to Saris Racing on Monday. Already looking forward to spring and new motor!
Padraig
Padraig
10-01-2024 | 04:31 PM
#14
Thread Starter
Registered
Joined: Oct 2000
Posts: 3,815
Likes: 678
From: Lakewood, NY, USA
Left the VR 1 at Performance Marine. Met, in person, Johnny and Jason Saris. Great guys. I feel very comfortable, leaving the VR 1 with them.
Joined the team. , 😁.
Joined the team. , 😁.
Last edited by Padraig; 10-01-2024 at 08:21 PM.
10-02-2024 | 10:43 AM
#18
Driver-441
Joined: Aug 2004
Posts: 12,017
Likes: 1,527
From: Lake George
If its a custom build we do prefer to be involved in the install or at least inspect the customer's install before the first ride.
Generally, because we do have our own ramp, docks and full service marina, its just easier for us to do the install and initial water test. That being said we dyno literally everything we do from stock valve jobs to full custom builds, so we do have a lot of confidence in our engines being drop in ready.
10-02-2024 | 01:01 PM
#19
Registered
Joined: Jun 2007
Posts: 7,345
Likes: 1,850
From: Merritt Island, FL
Either is fine.
If its a custom build we do prefer to be involved in the install or at least inspect the customer's install before the first ride.
Generally, because we do have our own ramp, docks and full service marina, its just easier for us to do the install and initial water test. That being said we dyno literally everything we do from stock valve jobs to full custom builds, so we do have a lot of confidence in our engines being drop in ready.
If its a custom build we do prefer to be involved in the install or at least inspect the customer's install before the first ride.
Generally, because we do have our own ramp, docks and full service marina, its just easier for us to do the install and initial water test. That being said we dyno literally everything we do from stock valve jobs to full custom builds, so we do have a lot of confidence in our engines being drop in ready.
On the dyno runs I think you had before said you dyno in full marine trim and not the "hero" trim a lot of shops do correct?
You know, PM me answers, no reason to take up the OP thread.
