Iron VS Aluminum heads
#232
Registered
this formula that I did the engines and tune ,went 112mph in a mile from a rolling 30mph.then theres my 30' going 107.4.you can watch my boat in action on my youtube channel,,disregard my knee
https://www.youtube.com/watch?v=OhwGR64_Ghw
https://www.youtube.com/watch?v=OhwGR64_Ghw
#233
Registered
Not to bad, since were talking about cyl heads, I can run those speeds as well with my 315s!! on 502s. Nice video sounds good.
But I have to say that there is no need to pick on Horsepower! for not having a boat I hope you can respect my opinion!
But I have to say that there is no need to pick on Horsepower! for not having a boat I hope you can respect my opinion!
#234
Banned
#235
Banned
Isn't that right, BIlly boy.
Heck, that's not fast. My first boat went 116 in four seconds. I'd like to take Billy boy for a ride in that one. He'd shat himself.
#237
Registered
http://www.yellowbullet.com/forum/sh....php?t=1537217
#238
Registered
That's all he's got. It happens every time he says something stupid and doesn't know what he's talking about. He resorts to the personal attacks. He;s not even an engine builder LOL...he sweeps floors and cleans parts.
Isn't that right, BIlly boy.
Heck, that's not fast. My first boat went 116 in four seconds. I'd like to take Billy boy for a ride in that one. He'd shat himself.
Isn't that right, BIlly boy.
Heck, that's not fast. My first boat went 116 in four seconds. I'd like to take Billy boy for a ride in that one. He'd shat himself.
And I'm pretty sure that last line is a lie.
#239
Banned
And what the heck is a 332? NO such animal from AFR.
#240
Registered
Billy...if you go back and read you'll see where I said I didn't change the front of the port at all. I Increased the valve size, and ported the bowls and short turns, BIlly...bowls and short turns. I wanted the smaller cross section of the 315 and out-flow the 335s in the critical lift ranges.
And what the heck is a 332? NO such animal from AFR.
And what the heck is a 332? NO such animal from AFR.