Engine balance - Cast vs forged
#12
Registered
Thread Starter
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
I still have 1 365hp short block crazyhorse. It had a valve dropped in number 1 hole and split the cylinder.
Paradigm.. I think I am alright too. I once installed an eight cylinder flywheel on an in line 6 accidentally. Wow!! Suprised it didn't walk off the jack stands when it started. I'm going to look into balancing and if not to out of line get them done for peace of mind.
Thanks to everyone for their replies.
BT
Paradigm.. I think I am alright too. I once installed an eight cylinder flywheel on an in line 6 accidentally. Wow!! Suprised it didn't walk off the jack stands when it started. I'm going to look into balancing and if not to out of line get them done for peace of mind.
Thanks to everyone for their replies.
BT
#14
Registered
Thread Starter
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
Crazyhorse... I was planning to tear down for parts for a later hp engine, but have no particular plans. What would it be worth to you? Or better yet, got anything to trade?
BT
BT