MPI oil filter head. Restriction?
#35
Platinum Member
Platinum Member
Thread Starter
iTrader: (2)
If I want to run the HP 500 thermostatic head, it would be best to force all the oil through the cooler. I wonder if the thermostat side of the cooler can be plugged.
I’ll probably just use the MPI head and just leave it. Lol
I’ll probably just use the MPI head and just leave it. Lol
#36
Platinum Member
Platinum Member
Thread Starter
iTrader: (2)
I couldn’t live with the restriction in the filter head. The fitting is 8AN but is a little larger than the inside diameter of a 8AN fitting. With that I decided to pick up this:
Fairly inexpensive. I cutoff the shelf on the bracket where the original filter head sat. The new head will be mounted on the upright/vertical surface.
This will give fill flow from the filter.
Fairly inexpensive. I cutoff the shelf on the bracket where the original filter head sat. The new head will be mounted on the upright/vertical surface.
This will give fill flow from the filter.
The following users liked this post:
Gimme Fuel (04-27-2021)