Got screwed on a boat ..Need help
#31
VIP Member
VIP Member
( being that you’re facing the input shaft of the drive) and ( while still turning the input shaft) push the shift link into the shift link cavity and you should feel it snap into gear and the prop shaft should start turning in the direction for what would be forward for a r/h rotation prop ( which you have)
Last edited by JaayTeee; 06-18-2021 at 05:52 AM.
The following users liked this post:
ThisIsLivin (06-18-2021)
The following users liked this post:
SB (06-18-2021)
#35
Registered
iTrader: (1)
My first comment was in relation to changing the lower determines if its a B1, B2 or B3. Was not talking about gear ratios, hence why I posted the compatibility charts
My second comment based on what you talked about upper gear ratios and no mention of lower B3.
#37
Registered
iTrader: (1)
Oring kit only about $10 or so
Quicksilver #16755Q1 Bell Housing Installation Gasket Kit - MerCruiser Bravo Drives, 1-Set
Quicksilver #16755Q1 Bell Housing Installation Gasket Kit - MerCruiser Bravo Drives, 1-Set
#40
Thanks for all the help guys .. picking up outdrive in the morning I hope it works ..
also got a lot of the black plasti dip off . Here is the side of the hull . Not been cleaned or waxed yet
also got a lot of the black plasti dip off . Here is the side of the hull . Not been cleaned or waxed yet