Tunell raaammm!!!!
#152
Registered
Chamber softening adds volume. It pushesthe air and fuel toward the center of the cylinder. It will let you run more timing, compression or boost.
Completely different design than angle milling.
Completely different design than angle milling.
Last edited by underpsi68; 12-28-2021 at 09:38 AM.
#153
Registered
Good question. Doubt we'll ever know.
He started that thread asking how to tune it, then in the thread said he had the best tuner on earth.
Then couldn't take the heat from the crowd.
That's Cliff Notes on the deal.
He started that thread asking how to tune it, then in the thread said he had the best tuner on earth.
Then couldn't take the heat from the crowd.
That's Cliff Notes on the deal.
The following users liked this post:
ICDEDPPL (12-28-2021)
The following users liked this post:
ICDEDPPL (12-28-2021)
#155
Registered
iTrader: (1)
#156
Registered
iTrader: (7)
I just got off the phone with Tim Hogan in regards to a couple of manifolds. Really neat guy to talk to. I gave him a brief rundown on my builds and rpm range. They are about 12 to 14 weeks out currently. I really like the idea of him calculating out the runner length etc for desired RPM and use. He said they do quite few marine apps with great success. Honestly I was hoping he’d say 6 to 12 months out on delivery. Very nice piece but damm ramm 3,800.00 x 2. 😳
#157
Registered
Here's some more help though.
Also link from Raylar site. (notice the link address in the address bar once ya open it.) https://www.raylarengineering.com/im...e-manifold.jpg
The following users liked this post:
SB (12-28-2021)
#158
Registered
iTrader: (7)
You glared right past it in post #150.
Here's some more help though.
Also link from Raylar site. (notice the link address in the address bar once ya open it.) https://www.raylarengineering.com/im...e-manifold.jpg
Here's some more help though.
Also link from Raylar site. (notice the link address in the address bar once ya open it.) https://www.raylarengineering.com/im...e-manifold.jpg
The following users liked this post:
SB (12-28-2021)
#159
Registered
iTrader: (1)
You glared right past it in post #150.
Here's some more help though.
Also link from Raylar site. (notice the link address in the address bar once ya open it.) https://www.raylarengineering.com/im...e-manifold.jpg
Here's some more help though.
Also link from Raylar site. (notice the link address in the address bar once ya open it.) https://www.raylarengineering.com/im...e-manifold.jpg
I don’t see much unless I’m on Pornhub. Lololol
The following users liked this post:
getrdunn (12-28-2021)
#160
Platinum Member
Platinum Member
iTrader: (6)
that thing is fuggly.............
The following users liked this post:
SB (12-28-2021)