Circulating pump question
#1
Gold Member
Gold Member
Thread Starter
Circulating pump question
Picked up a new pump and was wondering what, if anything, I should use on the gaskets.
If I was installing it on a car I would use Permatex #2.
Since this is first I've done on a marine engine I don't know if thats really needed.
What do you guys use or think?
If I was installing it on a car I would use Permatex #2.
Since this is first I've done on a marine engine I don't know if thats really needed.
What do you guys use or think?
#3
Guest
Posts: n/a
Sounds good to me.
After you install it with Permatex #2 (also coat the bolts) run a continuity test between the water pump and the battery ground to make sure the pump is grounded otherwise it will corrode very fast. If there is no continuity, you should make a ground strap from 16 gauge wire, (stainless wire is the best).
Dennis Moore
Dennis Moore