tomcei winter project
#24
Registered
Thread Starter
Re: tomcei winter project
I'm hoping to get some input on a few configurations for gauge placement. I'm trying to work with the monster racing
series.
The tach and speedo are just shy of 6" (5"11/16) with bezels added. The others are approx 3"3/4.
According to my estimate I have about 8" of vertical room on the dash.
I want to plan for six accessory gauges.
I will be removing the alum. square plate from behind the steering hub. And the wheel will be replaced with a dino three spoke.
Basicly I need pros and cons on the pics. The helm/dash is being glassed in and re-gelled, so I will drill new holes.
I want to think of all my options before hand.
As the saying goes measure twice drill once
Pic on left is #1 pic on right is #2
series.
The tach and speedo are just shy of 6" (5"11/16) with bezels added. The others are approx 3"3/4.
According to my estimate I have about 8" of vertical room on the dash.
I want to plan for six accessory gauges.
I will be removing the alum. square plate from behind the steering hub. And the wheel will be replaced with a dino three spoke.
Basicly I need pros and cons on the pics. The helm/dash is being glassed in and re-gelled, so I will drill new holes.
I want to think of all my options before hand.
As the saying goes measure twice drill once
Pic on left is #1 pic on right is #2
#28
JC Performance Engines
Gold Member
Re: tomcei winter project
I go w/ #1. Install the main 6 gauges.
Then figure where you want the last 2.
I still say to get water pressure in that thing.
Then figure where you want the last 2.
I still say to get water pressure in that thing.