Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: rer233
Showing results 1 to 25 of 56
Search took 0.01 seconds.
Forum: Do It Yourself, Boating on a Budget
12-01-2021, 05:31 PM
Replies: 12
Views: 2,192
Posted By rer233

Neutral and ground swapped in one of the cords??

Neutral and ground swapped in one of the cords??
Forum: General Q & A
08-15-2021, 02:18 PM
Replies: 16
Views: 1,482
Posted By rer233

Why not try switching carbs?

Why not try switching carbs?
Forum: Electronics
07-25-2021, 03:00 PM
Replies: 9
Views: 1,309
Posted By rer233

4 trashed MSD boxes in 5 hours??

Check the voltage difference between the direct battery feed line to the MSD box and the switched hot lead to the box from your ignition switch (can't remember the max. allowable difference..) I had...
Forum: Swap Shop
04-12-2020, 12:23 PM
Replies: 13
Views: 2,342
Posted By rer233

Internal or external lines?

Internal or external lines?
Forum: Swap Shop
03-15-2020, 11:09 AM
Replies: 4
Views: 631
Posted By rer233

Internal or external lines?

Internal or external lines?
Forum: Do It Yourself, Boating on a Budget
07-21-2018, 12:52 PM
Replies: 5
Views: 1,056
Posted By rer233

Well, MSD strikes again- turns out the 8920 tach...

Well, MSD strikes again- turns out the 8920 tach adapter took a dump. Actually, I'm glad it turned out to not be the tach (box is much easier to find and probably cheaper than a 25 year old VDO...
Forum: Do It Yourself, Boating on a Budget
07-10-2018, 10:25 PM
Replies: 5
Views: 1,056
Posted By rer233

Another MSD failure??

Finally got the boat in the water Saturday, tach was DOA. I've been running a MSD distributor, 6m2l ignition box, blaster2 coil, and an 8920 tach adapter for the last 12-13 years without a problem...
Forum: Swap Shop
11-10-2017, 10:16 PM
Replies: 2
Views: 632
Posted By rer233

How much for trim cyls alone? Internal or...

How much for trim cyls alone? Internal or external lines?
Forum: Do It Yourself, Boating on a Budget
10-10-2017, 07:10 PM
Replies: 7
Views: 1,185
Posted By rer233

A few years back, I swapped cams in my 454...

A few years back, I swapped cams in my 454 equipped 233 Formula Interceptor. Didn't want to pull the motor, so I got a 4" hole saw, did some careful measuring, cut a hole in the seat frame, and slid...
Forum: Formula
09-26-2017, 07:37 PM
Replies: 21
Views: 8,352
Posted By rer233

All "professional" means is they're gettin' paid...

All "professional" means is they're gettin' paid for what they're doin'...
Forum: Formula
07-28-2017, 09:13 PM
Replies: 25
Views: 3,685
Posted By rer233

double post- sorry!

double post- sorry!
Forum: Formula
07-28-2017, 09:11 PM
Replies: 25
Views: 3,685
Posted By rer233

Looks like the big sister to my '79 233...

Looks like the big sister to my '79 233 Interceptor- most likely an early '80's model. Also, it had TRS drives, so you're gonna have to re-do the transom to go to Bravos (TRS transom cut outs are...
Forum: General Boating Discussion
06-06-2017, 09:44 PM
Replies: 28
Views: 5,846
Posted By rer233

I keep mine in the prop box- boat's kept on a...

I keep mine in the prop box- boat's kept on a trailer @ the marina. I pull the prop after each use (keeps some other AH from doing it for me.) Also, I've got CRS so bad, I can't even remember what...
Forum: Swap Shop
05-02-2017, 10:11 PM
Replies: 28
Views: 5,866
Posted By rer233

Any cabin hull windows?

Any cabin hull windows?
Forum: Formula
04-01-2017, 09:05 PM
Replies: 9
Views: 1,751
Posted By rer233

You ARE re-doing the transom-right? TRS and...

You ARE re-doing the transom-right? TRS and bravo/alpha cutouts are completely different...
Forum: Mid Atlantic US
09-15-2016, 06:32 PM
Replies: 10
Views: 4,014
Posted By rer233

Hope you're right, Dave. I really miss the old...

Hope you're right, Dave. I really miss the old "Gunpowder Cove" days...
Forum: Drives and Lower Units
06-18-2016, 09:11 PM
Replies: 3
Views: 921
Posted By rer233

NEVER run the engine on a bravo (or alpha)...

NEVER run the engine on a bravo (or alpha) equipped boat with the drive in the full trailer position- the u-joints will def. rattle. Drop the drive all the way down (or at least to the full trim...
Forum: Wanted
08-30-2015, 01:57 PM
Replies: 0
Views: 421
Posted By rer233

Wanted: 79 Formula Interceptor Port Hole WIndow

I have a 79 Formula 233 Interceptor and am looking for a fixed port hole window. I need 1, but will take 2 if you have them. Port holes that open would also be ok. The part that goes thru the...
Forum: General Q & A
08-17-2015, 09:35 PM
Replies: 61
Views: 61,971
Posted By rer233

Probably been thru 2 or 3 6m2 boxes on my 233...

Probably been thru 2 or 3 6m2 boxes on my 233 interceptor in the 15 or so years I've been running MSD. Box and coil are mounted on an aluminium plate on the transom. After talking to MSD after my...
Forum: Formula
12-25-2013, 12:31 AM
Replies: 22
Views: 11,602
Posted By rer233

'Nother '79 (233 interceptor bbc trs.)

'Nother '79 (233 interceptor bbc trs.)
Forum: Formula
08-18-2013, 07:40 PM
Replies: 18
Views: 2,301
Posted By rer233

Any plans for this year? Last year was fun!

Any plans for this year? Last year was fun!
Forum: Do It Yourself, Boating on a Budget
06-28-2013, 09:57 PM
Replies: 11
Views: 2,140
Posted By rer233

Actually, i never went back to the circ. pump-...

Actually, i never went back to the circ. pump- temps run 140 front, 120 rear. I've run the current setup for 8-9 years with no problems. Would also recommend running water and fuel pressure gauges...
Forum: Do It Yourself, Boating on a Budget
06-28-2013, 06:59 PM
Replies: 11
Views: 2,140
Posted By rer233

had a similar prob on my n/a 454 after installing...

had a similar prob on my n/a 454 after installing a stainless marine preheat crossover system- stuck and bent an exhaust valve (#8 i think) at idle. engine temp never got hot and i already had the...
Forum: Drives and Lower Units
04-24-2013, 09:36 PM
Replies: 2
Views: 1,605
Posted By rer233

Thanx, MDG- kinda what i figgered- like vinyl...

Thanx, MDG- kinda what i figgered- like vinyl replacement windows huh? gave my buddy the good news today- turns out the drive's on a 27' larson with a single 5.7- can you say SLUG?? think he's...
Forum: Drives and Lower Units
04-23-2013, 07:26 PM
Replies: 2
Views: 1,605
Posted By rer233

volvo penta composite drive

a buddy of mine is considering buying a boat with a volvo duo prop "composite" (plastic??) drive. any thoughts? Thanx.
Showing results 1 to 25 of 56
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.