Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 5
1
2
3
Last »
Search: Posts Made By: SmallPP
Showing results 1 to 25 of 108
Search took 0.01 seconds.
Forum: General Q & A
08-07-2007, 12:04 PM
Replies: 3
Views: 1,311
Posted By SmallPP

Leaking fuel injector(s)?

Leaking fuel injector(s)?
Forum: General Q & A
08-07-2007, 12:01 PM
Replies: 9
Views: 1,332
Posted By SmallPP

How about a switch to electric fuel pump(s)? I...

How about a switch to electric fuel pump(s)? I changed mine over, and it fires right off. I am using an Edelbrock carb also with choke plate completely removed (who boats in the winter???). I turn...
Forum: General Q & A
08-07-2007, 11:54 AM
Replies: 1
Views: 4,120
Posted By SmallPP

Seeking Used External Hydraulic Steering or External Damper for Alpha

Hi all. Now that I have my 17' Formula over 70mph, she dances left and right over 65mph if the drive trim is up pretty good. I'm not sure if this is caused by the play in the stock steering or not....
Forum: General Q & A
08-07-2007, 11:49 AM
Replies: 7
Views: 6,832
Posted By SmallPP

Not to slam DUI, I checked the above link and...

Not to slam DUI, I checked the above link and could not find any information saying they are Coast Guard approved. Stock HEI is not, and it should require cap sealing with spark arrestor vent...
Forum: Drives and Lower Units
08-07-2007, 08:34 AM
Replies: 1
Views: 3,704
Posted By SmallPP

It depends upon what engine you are using. I...

It depends upon what engine you are using. I swapped a 4.3L to a 5.7L in my boat, and the mounts went forward 4". I think SBC and BBC are same location, but I am not sure.

If you are using a...
Forum: Drives and Lower Units
08-07-2007, 08:30 AM
Replies: 6
Views: 1,155
Posted By SmallPP

I'm also running 400hp through my 1984 Alpha. No...

I'm also running 400hp through my 1984 Alpha. No problems. Only upgrade is re-sealed and re-shimmed drive, added drive shower, and check drive oil before every outing (soon adding remote tank for...
Forum: General Q & A
08-07-2007, 08:16 AM
Replies: 20
Views: 4,566
Posted By SmallPP

Oil temp is most important when doing this. Do...

Oil temp is most important when doing this. Do not exceed 300F, target temp is just above water boiling, around 212F but you won't be able to keep it there at WOT.

Also, check the oil level...
Forum: Drives and Lower Units
08-07-2007, 08:07 AM
Replies: 6
Views: 6,193
Posted By SmallPP

I have heard of this, and from what I understand,...

I have heard of this, and from what I understand, the only difference between transom plates is the Bravo has 2 extra studs, lower I believe. All else should line up.

I have not done it, but...
Forum: General Q & A
08-03-2007, 11:01 AM
Replies: 17
Views: 13,968
Posted By SmallPP

Breathers are upstairs, oil is downstairs. Your...

Breathers are upstairs, oil is downstairs. Your problem is in the basement. You can test to see if windage is the problem by lowering your oil level 1-2 quarts. Watch gauge closely and only do...
Forum: General Q & A
08-03-2007, 09:27 AM
Replies: 8
Views: 1,682
Posted By SmallPP

Stay basic at first. Check fuel and air flow. ...

Stay basic at first. Check fuel and air flow. Replace water seperator, check filter inside Q-Jet carb (if that is what you have), clean flame arrestor with carb cleaner, most daily boaters never do...
Forum: General Q & A
08-03-2007, 09:21 AM
Replies: 3
Views: 8,524
Posted By SmallPP

If you want to improve the system further,...

If you want to improve the system further, contact me. I have made an automated activation kit which allows you to run the exhaust in 3 modes, all from a dash switch while running:

1. Exhaust...
Forum: General Q & A
08-03-2007, 09:11 AM
Replies: 17
Views: 13,968
Posted By SmallPP

Could also be windage. If the oil level is too...

Could also be windage. If the oil level is too high, the crankshaft counterweights are beating air bubbles into the oil, and sucked up by oil pump. I'd try dropping the oil level 1-2 quarts and do...
Forum: General Q & A
08-01-2007, 12:42 PM
Replies: 16
Views: 13,875
Posted By SmallPP

Super information, thank you. I'm looking to...

Super information, thank you. I'm looking to have it all in under 4000rpm, the boat is very light so risk of knock is virtually zero. Now just need to find one used !!!

As an added note, I...
Forum: General Q & A
08-01-2007, 09:36 AM
Replies: 16
Views: 13,875
Posted By SmallPP

Thanks for the lessons. How do I tell the...

Thanks for the lessons. How do I tell the difference between modules, which one gives the advance earlier? I'd prefer that one.

My motor (5.7L, 350 Vortec Roller) is using the largest...
Forum: General Q & A
07-30-2007, 02:06 PM
Replies: 16
Views: 13,875
Posted By SmallPP

Cuda thanks for the words. Do you know why a V6...

Cuda thanks for the words. Do you know why a V6 module will not advance as far as printed? I see some people use them here. What is the science with them?

I should have bought your 242, I...
Forum: General Q & A
07-30-2007, 02:04 PM
Replies: 16
Views: 13,875
Posted By SmallPP

Still Seeking

Hi folks. Still seeking a used MerCruiser Thunderbolt V8 distributor, and module. Not sure if I want V6 or V8 module, seems a little confusing, some say V6 does timing advance earlier, but another...
Forum: General Q & A
07-20-2007, 03:21 PM
Replies: 16
Views: 13,875
Posted By SmallPP

Is it for a V6 enigne? I want one from a 4.3L,...

Is it for a V6 enigne? I want one from a 4.3L, not a 350 (5.7L). I am going to use a V6 module on a V8.
Forum: General Q & A
07-20-2007, 02:01 PM
Replies: 16
Views: 13,875
Posted By SmallPP

Seeking Thunderbolt V6 Ignition Module

Hello, I apologize for probably not placing my writing in the correct spot, but classifieds seemed to be full of new products only, so I thought I would try here.

Have late model mild-build 350...
Forum: General Q & A
06-12-2006, 04:24 PM
Replies: 3
Views: 5,206
Posted By SmallPP

Best Flame Arrestor Flow ???

I have done a search for what I am seeking and only find folks horse trading flame arrestors. Does anybody have a strong recommendation to a style of flame arrestor for improvement over stock for...
Forum: General Q & A
03-08-2006, 08:10 AM
Replies: 0
Views: 864
Posted By SmallPP

Talking Gear / Prop Combo Suggestion

Hi all, it has been a while since I have written. I have a 17' Formula I/O Alpha 1 originally equipped with a 4.3L V6, which I have exchanged for a mildly built late model Vortec 350 (5.7L, under...
Forum: General Q & A
11-11-2005, 10:41 AM
Replies: 31
Views: 4,753
Posted By SmallPP

Re: A Challenge = Free Lunch

Send them to my house. I don't care if anybody knows where I live, it's just a small brick ranch anyway.

Clint McDermott
10029 Basett
Livonia, MI 48150

Thanks bud. Hope they come through...
Forum: General Q & A
11-10-2005, 06:06 AM
Replies: 11
Views: 1,807
Posted By SmallPP

Re: Speeding up bolster seat speed

You could increase the voltage to the motors. They are short term run, so no damage will occur. If you have 2 batteries, you could run a series circuit to them to double their speed = 24v.
Forum: General Q & A
11-09-2005, 07:51 PM
Replies: 31
Views: 4,753
Posted By SmallPP

Attn HillBilly24

Hello? Any chance you could send those fittings? I could still pay ya. Let me know. Thanks. Sorry to "page" ya. Hope all is well.
Forum: General Q & A
11-02-2005, 09:50 AM
Replies: 31
Views: 4,753
Posted By SmallPP

Attn: HillBilly24

How bout' them fittings?
Forum: General Q & A
11-02-2005, 09:47 AM
Replies: 5
Views: 8,703
Posted By SmallPP

Re: Correct Stack Up 4 Rear Mount Bolts (Alpha)

We're close, but stil not clear. Check

http://216.37.204.206/Shorts/mercruiser_oem/Mercruiser.asp?Type=13&SubType=113&A=39&B=24

and let me know where the rear motor plate fits between parts...
Showing results 1 to 25 of 108
 
Page 1 of 5
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.