Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: Rocko C
Showing results 1 to 25 of 106
Search took 0.01 seconds.
Forum: Baja
08-15-2012, 01:20 PM
Replies: 10
Views: 3,181
Posted By Rocko C

Bravo III on a 25 Outlaw ?

My outdrive needs replacement. My buddy at the Merc dealership asked me if I would be going with a B1X again or a BIIIX ? I looked at him like he was speaking Farsi. I told him I didn't think a BIII...
Forum: Baja
07-28-2009, 01:48 PM
Replies: 9
Views: 6,697
Posted By Rocko C

I have a 2000 25 OL. I did the repairs in...

I have a 2000 25 OL. I did the repairs in reverse order for the sake of $$$. I replaced my original steering helm/steering cable with a new Teleflex Tilt helm and cable and the side to side play...
Forum: General Q & A
07-25-2009, 08:31 AM
Replies: 5
Views: 4,973
Posted By Rocko C

I was seriously considering the Superflush system...

I was seriously considering the Superflush system myself but due to the higher price and more complicated install, I went with the Volvo system. Is the Superflush system better ? Maybe but, to me,...
Forum: General Q & A
07-24-2009, 12:50 PM
Replies: 5
Views: 4,973
Posted By Rocko C

I've been using the Perko kit for the past few...

I've been using the Perko kit for the past few years along with the salt away mixer and solution. Very thorough but a P.I.T.A. when you just want to kill the engine at the end of a long day and go...
Forum: General Q & A
06-29-2009, 09:23 PM
Replies: 0
Views: 569
Posted By Rocko C

Nutty smelling white smoke...

I had water in the oil due to a leaking port side manifold. I also had a leaking valve cover. I replaced the gasket and both manifolds/elbows. Everything is sealed tight as a drum. I used carb...
Forum: General Q & A
06-28-2009, 03:14 PM
Replies: 7
Views: 5,077
Posted By Rocko C

Ok, guys...thanks for all the replies. I believe...

Ok, guys...thanks for all the replies. I believe I have my answer.

Rock
Forum: General Q & A
06-28-2009, 07:27 AM
Replies: 7
Views: 5,077
Posted By Rocko C

The rockers my motor uses are pictured below. I...

The rockers my motor uses are pictured below. I believe they are roller rockers (not sure what the difference is). I already put the valve cover back on or I would have taken a pic of them.
...
Forum: General Q & A
06-27-2009, 05:44 PM
Replies: 7
Views: 5,077
Posted By Rocko C

Rocker arms a little rusted...

Long story short...manifolds failed, let water in motor. Had motor flushed out, new manifolds/elbows but still had an oil leak. I pulled the port side valve cover and it was caked with white goo...
Forum: Baja
06-01-2009, 07:32 AM
Replies: 1
Views: 1,293
Posted By Rocko C

It's pretty easy, I just did it last weekend. I...

It's pretty easy, I just did it last weekend. I have a 502, by the way.

1. Disconnect the ground from the battery to make sure that there is no power to the starter. This can be confirmed by...
Forum: Baja
04-08-2009, 06:55 PM
Replies: 0
Views: 848
Posted By Rocko C

Lenco/Livorsi wiring...

To all who have the Lenco trim tabs / Livorsi gauge setup: If someone gets the chance, I need the colors and locations of the wiring from the Lenco harness to the trim tab switches. The harness has...
Forum: Baja
03-31-2009, 01:25 PM
Replies: 7
Views: 7,157
Posted By Rocko C

From what I've read on all of the major trim tab...

From what I've read on all of the major trim tab manufacturer's websites, the inside edge of the tab should not be within 2" of the nearest strake. If it is "move the tab to the left until it covers...
Forum: Baja
03-31-2009, 08:32 AM
Replies: 7
Views: 7,157
Posted By Rocko C

BajaWill, I can't see under the tabs in the...

BajaWill,
I can't see under the tabs in the pics. Is there a strake under them ? Thanks for posting the pics.

Rock
Forum: Baja
03-30-2009, 01:24 PM
Replies: 7
Views: 7,157
Posted By Rocko C

Trim Tabs and Strakes...

I have a new set of Lenco HD trim tabs that are 14W x 18D. In the Lenco instructions and elsewhere on the internet, it says to mount them at least 2" away from the nearest strake. If I start mine...
Forum: Baja
03-02-2009, 05:12 PM
Replies: 2
Views: 730
Posted By Rocko C

I had the same problem at the end of '07. ...

I had the same problem at the end of '07. Everything appeared fine, no leaks, fluid level good, etc. It was the P/S pump. I couldn't figure it out since, to me, the pump was fine. It wasn't, I...
Forum: General Q & A
06-26-2008, 02:01 PM
Replies: 7
Views: 1,378
Posted By Rocko C

Any idea if this gasket will work in GM's new...

Any idea if this gasket will work in GM's new valve covers with the groove in them ? My existing gasket is a round, black o-ring looking gasket and it's leaking. I'd love to go with a Felpro if it...
Forum: Baja
06-22-2008, 09:54 AM
Replies: 6
Views: 12,585
Posted By Rocko C

Oh yeah, all Baja models are covered. This is...

Oh yeah, all Baja models are covered. This is the link: http://www.bajamarine.com/ownersmanuals.asp?tab=3&formurl=index.asp&

Rock
Forum: Baja
06-22-2008, 07:56 AM
Replies: 6
Views: 12,585
Posted By Rocko C

Thumbs up Baja parts manual - 25 Outlaw (all years)

Look what I found tucked away on Baja's website. It's got all of the parts in your 25 Outlaw listed by section and number. Some listings even have the manufacturer's number listed. The listing for...
Forum: General Q & A
06-22-2008, 07:47 AM
Replies: 2
Views: 829
Posted By Rocko C

Thanks Smitty, that's what I was afraid of. A...

Thanks Smitty, that's what I was afraid of. A project best set aside for when I have an entire day to devote to it. Thanks for the fix.

Rock
Forum: General Q & A
06-22-2008, 07:44 AM
Replies: 2
Views: 1,126
Posted By Rocko C

I have a wet exhaust system. As the water exits...

I have a wet exhaust system. As the water exits the riser and goes through the Corsa diverters, some of the water is leaking out of the hose that connects the diverter to the exhaust tip. I may...
Forum: General Q & A
06-20-2008, 02:20 PM
Replies: 2
Views: 1,126
Posted By Rocko C

Water in bilge problem identified...now to fix it

Ok, here's the back-story...

Last year, noticed a ton of water in the bilge after every few hours or so. Figure'd it was a leak at the transom (tiller arm seal, bellows, etc.). Had it checked, no...
Forum: General Q & A
06-20-2008, 02:19 PM
Replies: 2
Views: 829
Posted By Rocko C

HELP with fuel rail plugs...

I tried to remove the stock plug on the back of the fuel rail in order to mount a sender, with the correct size allen wrench, mind you. No luck, it just stripped out. I bought a kit for stripped...
Forum: General Q & A
06-11-2008, 12:48 PM
Replies: 1
Views: 559
Posted By Rocko C

Try doing some Google searches for Aeromotive...

Try doing some Google searches for Aeromotive pumps. That's the pump that came with my M3-SC setup. Yours may be an older Aero pump.

Rock
06-10-2008, 12:46 PM
Replies: 3
Views: 7,089
Posted By Rocko C

I upgraded my 2000 Bravo I to a new Bravo X last...

I upgraded my 2000 Bravo I to a new Bravo X last year. No mods were necessary. I have the standard transom assembly, by the way, not the HP.

Rock
Forum: General Q & A
06-06-2008, 08:53 AM
Replies: 11
Views: 2,865
Posted By Rocko C

Brian, FYI...I re-powered last year with a...

Brian,
FYI...I re-powered last year with a new 502 from Marine Power Service. The motor now has 100 hours on it and is rock solid. MPS was great to deal with. They actually had three base...
Forum: General Q & A
05-30-2008, 12:31 PM
Replies: 12
Views: 4,886
Posted By Rocko C

I had the same problem last season, over two...

I had the same problem last season, over two inches of side to side play...no up and down play, though. I had the helm and steering cable replaced and now have less than an inch of play. One...
Showing results 1 to 25 of 106
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.