Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 11 of 20
« First
9
10
11
12
13
Last »
Search: Posts Made By: hoozeyurdaddy
Showing results 251 to 275 of 500
Search took 0.02 seconds; generated 74 minute(s) ago.
Forum: General Q & A
02-16-2009, 09:45 AM
Replies: 10
Views: 1,232
Posted By hoozeyurdaddy

or at some point it had trim/tilt controls on the...

or at some point it had trim/tilt controls on the dash?
Forum: General Q & A
02-16-2009, 09:41 AM
Replies: 10
Views: 1,232
Posted By hoozeyurdaddy

it sounds like they are trim and tilt wires, if...

it sounds like they are trim and tilt wires, if the sys. is working fine, I would just put a butt connector on the end of each wire, so they can't short out and tape up the wires out of the way.
Forum: General Q & A
02-16-2009, 09:35 AM
Replies: 8
Views: 912
Posted By hoozeyurdaddy

once you've got all the slop out of the pushrods,...

once you've got all the slop out of the pushrods, I will go 3/4 to 1 turn, did they give you any instructions for the lifters.
Forum: General Q & A
02-16-2009, 09:30 AM
Replies: 19
Views: 3,651
Posted By hoozeyurdaddy

here's a little helpful info if you've got the...

here's a little helpful info if you've got the timing cover off, when the timing dots are lined up with each other, that is #6 TDC firing stroke, rotate crank 360 deg for #1
Forum: General Q & A
02-16-2009, 09:10 AM
Replies: 8
Views: 1,113
Posted By hoozeyurdaddy

What size of boat is this? is a big block going...

What size of boat is this? is a big block going to fit? will the hull stand up to a big block? Weight, speed,ect?
Forum: General Q & A
02-16-2009, 09:05 AM
Replies: 8
Views: 1,401
Posted By hoozeyurdaddy

do the fitting come out of the new pump?

do the fitting come out of the new pump?
Forum: General Q & A
02-16-2009, 09:03 AM
Replies: 1
Views: 689
Posted By hoozeyurdaddy

first, if the generator is going to be in the...

first, if the generator is going to be in the engine compartment, it has to be a marine gen. watercooled and spark protected, you can run some stuff with an inverter, but they are not very efficent,...
Forum: General Q & A
02-16-2009, 08:51 AM
Replies: 3
Views: 765
Posted By hoozeyurdaddy

I dont know what style the talon has. this cat...

I dont know what style the talon has. this cat has a center sponson that is about 10-12" at the rear and main sponsons have 2 steps.
Forum: General Q & A
02-15-2009, 09:39 AM
Replies: 3
Views: 765
Posted By hoozeyurdaddy

big power in 280 profile

Does anyone know of someone who is running 1000hp+ in a 28 profile cat, if so how does it handle the power and how fast does it run. I'm looking to up the hp, running 830hp now with naturally...
Forum: Swap Shop
02-14-2009, 09:22 AM
Replies: 17
Views: 4,140
Posted By hoozeyurdaddy

If anyone is still looking for a stern jack, I...

If anyone is still looking for a stern jack, I have a bravo jack in great condition, will take $1500.00 for it with the extended ram's included, shift cable, studs, it's all there. I will throw in 2...
Forum: General Q & A
02-02-2009, 11:49 AM
Replies: 5
Views: 730
Posted By hoozeyurdaddy

where at in e-bay and what is DiaCom?

where at in e-bay and what is DiaCom?
Forum: General Q & A
02-02-2009, 08:46 AM
Replies: 5
Views: 730
Posted By hoozeyurdaddy

Merc code reader needed

Is there a aftermarket reader for merc mefi 1,2,& 3 or do I need to buy a merc tool? does anyone now where to get one?
Larry
Forum: Wanted
12-28-2008, 10:29 AM
Replies: 0
Views: 588
Posted By hoozeyurdaddy

Need 14/71 Blower

I'm looking for a used 14-71 set up for a tall deck, need full setup for a 622 ci, looking to run about 5 psi with out cooler.
thanks
larry
Forum: Drives and Lower Units
11-05-2008, 08:59 AM
Replies: 2
Views: 961
Posted By hoozeyurdaddy

let us know when the drive is off, I'm sure there...

let us know when the drive is off, I'm sure there is plenty of us on here with experience on the omc stringer's and cobra's

Larry
Forum: Drives and Lower Units
11-03-2008, 06:36 AM
Replies: 3
Views: 835
Posted By hoozeyurdaddy

thanks for that link, with that I was able to...

thanks for that link, with that I was able to figure out what it would be.
Larry
Forum: General Q & A
11-02-2008, 08:38 AM
Replies: 10
Views: 4,335
Posted By hoozeyurdaddy

is the merc sys. as good on fuel as the...

is the merc sys. as good on fuel as the aftermarkets, is there an o2 sensor on the merc sys.? thats what this customer is after.
Forum: Drives and Lower Units
11-02-2008, 08:28 AM
Replies: 3
Views: 835
Posted By hoozeyurdaddy

what would the ratio be for this set-up

I'm changing a 2.00:1 B2 drive into a B3, changing only the lowers. The B2 is stamped on the upper 2.00:1 and the B3's upper was stamped 2.20:1, what am I going to end up with?
I beleive they both...
Forum: General Q & A
11-02-2008, 06:17 AM
Replies: 193
Views: 71,667
Posted By hoozeyurdaddy

I got 830+ hp out of my 622ci N/A with 91 octane...

I got 830+ hp out of my 622ci N/A with 91 octane and cmi big tubes, and single 1150 carb. but I would love to find a 1471 to put on it. It's no match for some of the motors listed, but for a na it...
Forum: General Q & A
11-02-2008, 06:03 AM
Replies: 10
Views: 4,335
Posted By hoozeyurdaddy

thanks for the info guy's, this sys. is going on...

thanks for the info guy's, this sys. is going on a customers boat and I what simple, if there is such a thing. it's a older gentelmen that owns the boat and is not mechanically inclined at all, all...
Forum: General Q & A
10-30-2008, 12:17 PM
Replies: 10
Views: 4,335
Posted By hoozeyurdaddy

info on aftermarket FI for 7.4L 330hp

looking to install a aftermarket fuel injection sys. on a 1995 7.4L merc, any pro's and con's between the edelbrock sys. MPFI or the holley MPFI or the TBI. not looking so much for performance...
Forum: Swap Shop
10-21-2008, 05:34 PM
Replies: 0
Views: 2,166
Posted By hoozeyurdaddy

Bravo 1.65:1 Gear set

NIB Bravo upper gear set P/N 43-883479A 4 1.65:1 ratio
Retails for $1536.45, will let go for $1000.00.
Forum: General Q & A
09-20-2008, 10:23 AM
Replies: 3
Views: 2,896
Posted By hoozeyurdaddy

I've used sierra's and merc's, the only...

I've used sierra's and merc's, the only difference was price.
Forum: Swap Shop
08-28-2008, 08:32 AM
Replies: 2
Views: 1,963
Posted By hoozeyurdaddy

gibson turndown's

Gibson 4.5X12X12 turndowns, test time only, look brand new, ended up using the shorter set. payed $400, taking offers.
Forum: General Q & A
08-18-2008, 09:11 AM
Replies: 11
Views: 2,068
Posted By hoozeyurdaddy

I love the avitar, it say's it all, but did you...

I love the avitar, it say's it all, but did you forget to switch it from the uncensored?
Forum: General Q & A
08-09-2008, 10:14 AM
Replies: 8
Views: 6,698
Posted By hoozeyurdaddy

what he is asking, is it fuel injected or carbed?

what he is asking, is it fuel injected or carbed?
Showing results 251 to 275 of 500
 
Page 11 of 20
« First
9
10
11
12
13
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.