Offshoreonly.com - Search Results

Search: Posts Made By: Rbesola

Showing results 476 to 500 of 500
Search took 0.02 seconds; generated 56 minute(s) ago.

Forum: Cigarette

12-27-2012, 08:54 AM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Just down river from spring valley.also known as...

Just down river from spring valley.also known as white sand beaches.

Forum: Cigarette

12-26-2012, 04:24 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Bill Dahl here in peoria told me 1.5-2" above the...

Bill Dahl here in peoria told me 1.5-2" above the bottom but everyone else says even or just below so i hope i made the right choice going that deep. He has a 38' Sutphen with the same setup and...

Forum: Cigarette

12-25-2012, 07:06 AM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

The reason i had to have it when the opertunity...

The reason i had to have it when the opertunity came up!:evilb:

Forum: Cigarette

12-25-2012, 07:03 AM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Rerigged with #4s on boxes 1" below hull (started...

Rerigged with #4s on boxes 1" below hull (started from scratch)

Forum: Drives and Lower Units

12-23-2012, 05:00 PM

Replies: 0

where to find trim hose fittings

Views: 845

Posted By Rbesola

where to find trim hose fittings

I converted from trs to #4s on boxes and they came with 6 foot hoses but i need to shorten mine and put preferably female ends on like a compression type fitting that i dont need to crimp the...

Forum: Trucks, Trailers and Transportation

12-21-2012, 05:22 PM

Replies: 3

Class 8 r/v and trailer registration???

Views: 826

Posted By Rbesola

Nobody has any insight on this?

Nobody has any insight on this?

Forum: Cigarette

12-21-2012, 05:22 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

What do you have for a boat?Ill have to keep an...

What do you have for a boat?Ill have to keep an eye out!

Forum: Cigarette

12-21-2012, 06:43 AM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

I spend a good amount of time there.i actually...

I spend a good amount of time there.i actually belong to spring valley boat club just down river.not my ideal location for performance boating but we do have a very active boating community between...

Forum: Cigarette

12-20-2012, 09:25 AM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Wow!?!?!?and i thought 5/8" was bad!

Wow!?!?!?and i thought 5/8" was bad!

Forum: Cigarette

12-19-2012, 04:10 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Let me rephrase, the boats almost ready for warm...

Let me rephrase, the boats almost ready for warm weather.if only i could take the boat to Jamaica next month.lol

Forum: Cigarette

12-19-2012, 04:08 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Definitely learning alot.had to find a tail...

Definitely learning alot.had to find a tail stock, rebuild the other, replace gimble ring, run all new steering, play with ppg's concept series paint and hopefully soon experiment with...

Forum: Cigarette

12-19-2012, 02:13 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Layed out, cut holes, hung the new hardware,...

Layed out, cut holes, hung the new hardware, checked, disassembled, painted and ready to throw it back together.

Forum: Cigarette

12-19-2012, 01:49 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Bottom center of transom up and over.jacked boat...

Bottom center of transom up and over.jacked boat level shot a laser across at the first chine on both sides.also ran 2 8' straight edges along the bottom.also measured from notch up.for good measure...

Forum: Cigarette

12-19-2012, 12:39 PM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

Center lines seem to be good.the heights...

Center lines seem to be good.the heights are(were) just off by a mile.

Forum: Cigarette

12-19-2012, 10:42 AM

Replies: 29

factory rigged x-dim off 5/8" side for side?

Views: 4,337

Posted By Rbesola

factory rigged x-dim off 5/8" side for side?

Anyone else ever ran into this? My port drive was 5/8" higher than my star.noticed this when i layed out my new holes and its quite obvious.possibly why my boat handled for spit.i measured and...

Forum: Baja

12-16-2012, 03:28 PM

Replies: 8

yellowed vinyl in a Baja

Views: 1,701

Posted By Rbesola

Clorox cleanup worked well for me.stay away from...

Clorox cleanup worked well for me.stay away from colored stitching and embroidery though.also uses magic erasers for scuffs and nail polish and such.

Forum: Trucks, Trailers and Transportation

12-16-2012, 03:16 PM

Replies: 31

06 f350 sound bad starting

Views: 5,110

Posted By Rbesola

Well put. Good motors if you know a little about...

Well put. Good motors if you know a little about how they operate. hard warm starts sounds like a hpop leak since the problem is worse with warm(thin) oil.

Forum: Trucks, Trailers and Transportation

12-16-2012, 09:45 AM

Replies: 3

Class 8 r/v and trailer registration???

Views: 826

Posted By Rbesola

Class 8 r/v and trailer registration???

I'm currently towing with a F350 with D plates and a TG(20k) on the trailer. $420 a year just in plates. I've been wanting to restore an old W900A and register it as an rv which isnt an issue....

Forum: General Q & A

12-16-2012, 09:33 AM

Replies: 40

EXHAUST TIPS: Straight or Angle Cut?

Views: 28,742

Posted By Rbesola

just my opinion but the straight cuts have an...

just my opinion but the straight cuts have an "old school, agressive" look.

Forum: Trucks, Trailers and Transportation

12-09-2012, 09:42 AM

Replies: 821

Post the pics of your rig

Views: 411,751

Posted By Rbesola

So does anyone tow with a semi?im looking for an...

So does anyone tow with a semi?im looking for an old W900A to restore an tow with.go big or go home:evilb:

Forum: Wanted

12-06-2012, 10:15 PM

Replies: 1

Wanted: Corsa Captain's Call or equiv

Views: 484

Posted By Rbesola

i've got two sets now that i went ssm i cant...

i've got two sets now that i went ssm i cant use.Corsa and electric

Forum: Trucks, Trailers and Transportation

12-06-2012, 10:01 PM

Replies: 821

Post the pics of your rig

Views: 411,751

Posted By Rbesola

im on the org and cummins forumn. not very often...

im on the org and cummins forumn. not very often though. kinda lost interest due to the fact that most of the modded diesel guys are idiots:lolhit:

Forum: Trucks, Trailers and Transportation

12-05-2012, 07:49 PM

Replies: 821

Post the pics of your rig

Views: 411,751

Posted By Rbesola

Most of the stuff i did, im a fabricator by...

Most of the stuff i did, im a fabricator by trade, and bought things like sending unit adapters, tach conversion kit but mostly just lot of searching for places to either buy odds and ends or have it...

Forum: Trucks, Trailers and Transportation

12-04-2012, 07:43 PM

Replies: 821

Post the pics of your rig

Views: 411,751

Posted By Rbesola

Cummins power!:bunnydance: ...

Cummins power!:bunnydance:
http://i747.photobucket.com/albums/xx117/rbesola/Facebook/Mobile%20Uploads/336713_325226097504844_824584332_o.jpg

Forum: General Boating Discussion

12-02-2012, 05:42 PM

Replies: 36

Twins to be or not to be

Views: 5,915

Posted By Rbesola

I had a 290 power quest i sold a year ago with...

I had a 290 power quest i sold a year ago with twin 454mpi's 45mph cruise, 70mph wot and 2.7mph regardless of speed.won't find better reliability than low hp twins.

Showing results 476 to 500 of 500