Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 3 of 4
1
2
3
4
Search: Posts Made By: Warlock28SXT
Showing results 51 to 75 of 86
Search took 0.00 seconds; generated 60 minute(s) ago.
Forum: General Q & A
05-10-2008, 11:31 AM
Replies: 38
Views: 6,864
Posted By Warlock28SXT

Has anyone used/tried this??????

http://MEFIBurn.com
Forum: General Q & A
05-05-2008, 08:58 PM
Replies: 8
Views: 1,588
Posted By Warlock28SXT

Steve Can you move the switch out to gain more...

Steve
Can you move the switch out to gain more access? Have any pics. I don't know of any boxes you could install, but moving the switch might me a bit easier than cutting a large hole in your...
Forum: General Q & A
05-05-2008, 08:48 PM
Replies: 10
Views: 4,307
Posted By Warlock28SXT

Paulkairis If you look close at the pic you can...

Paulkairis
If you look close at the pic you can see that there is a clamp just past the o2. I removed the tail pipe, with the bung close to the end of the collector you have enough room to weld both...
Forum: General Q & A
05-05-2008, 10:12 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I tried the NGK 2756 with no change and now after...

I tried the NGK 2756 with no change and now after reading on OSO I bought NGK 4554. I don't know how they work due to a sea water pump failure. Anyway I should be able to get out today, baring any...
Forum: General Q & A
05-02-2008, 11:31 AM
Replies: 10
Views: 4,307
Posted By Warlock28SXT

Here is where I have installed my o2 sensor. I...

Here is where I have installed my o2 sensor. I spoke with CMI for placement. The sensor should be higher in the the end of the collector due to water/condensation sitting on the sensor. I leave the...
Forum: General Boating Discussion
04-30-2008, 08:23 AM
Replies: 13
Views: 2,469
Posted By Warlock28SXT

The rough bottom helps to break the surface...

The rough bottom helps to break the surface tension of the water, yes giving a little more speed like Chris S stated. After a few high speed runs, the bottom will smooth back out form the friction of...
Forum: General Boating Discussion
04-29-2008, 09:04 AM
Replies: 29
Views: 16,620
Posted By Warlock28SXT

I had a 18' Hydrostream Valero with a 2.4...

I had a 18' Hydrostream Valero with a 2.4 Bridgeport on it. 6" jack plate, foot feed & trim in the wheel. That was a riot to drive. Chine walk was an issue when you would string it out. Although...
Forum: General Q & A
04-28-2008, 04:09 PM
Replies: 1
Views: 1,587
Posted By Warlock28SXT

You might have better luck posting in the "Prop...

You might have better luck posting in the "Prop Talk" section....
Forum: General Q & A
04-25-2008, 09:41 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

Thanks for the call Griswald. I will try and get...

Thanks for the call Griswald. I will try and get a hold of him today. I'll let you know.
Forum: General Q & A
04-25-2008, 09:30 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I forget the manufacturer of the reg it's just...

I forget the manufacturer of the reg it's just like the factory one but adjustable. The little reg on the front of the rail. If I redo the fuel system it will have to go and I will have to run one...
Forum: General Q & A
04-25-2008, 09:15 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I never thought of dead heading the fuel into the...

I never thought of dead heading the fuel into the rail. I just worked with the way it was through the rail. I can give this a shot as well thanks for the claification. Should I feed both sides or...
Forum: General Q & A
04-25-2008, 08:37 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

Yes the adjustable reg is at the from of the...

Yes the adjustable reg is at the from of the rail. The return of the fuel rail them goes to the FMU. It is the stock location except that it is adjustable.
Forum: General Q & A
04-25-2008, 08:26 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I have an adjustable regulator on the front of...

I have an adjustable regulator on the front of the fuel rail, so the output of that goes to the cartech. Fuel pressure does adjust from idle through atmospheric press and into boost. The difference...
Forum: General Q & A
04-25-2008, 07:44 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

Griswald Thats good to hear. I have got a lot...

Griswald
Thats good to hear. I have got a lot of info from everybody here. I think I just need to take a step back and look from the beginning. You ever head the K.I.S.S. theory? Keep It Simple...
Forum: General Q & A
04-24-2008, 07:41 PM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

Thanks that's a good idea. I guess total control...

Thanks that's a good idea. I guess total control of tuning would be great, I can burn down a motor with the best of them.:D
Forum: General Q & A
04-24-2008, 07:29 PM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I have considered going to a Mefi3, but at this...

I have considered going to a Mefi3, but at this point I wish to make it run as good as it can as is. Rain for the next few days we will see what transpires when the weather breaks.
Forum: General Q & A
04-24-2008, 03:25 PM
Replies: 4
Views: 4,309
Posted By Warlock28SXT

I had the same issue with my Gafrig as well. THe...

I had the same issue with my Gafrig as well. THe gauge would go through it's normal sweep then come back to about 33MPH and sit there. In my case it ended up being the gauge. I went down to Livorsi...
Forum: General Boating Discussion
04-24-2008, 10:25 AM
Replies: 22
Views: 2,639
Posted By Warlock28SXT

Where in Wisconsin are you? Maybe I could help...

Where in Wisconsin are you? Maybe I could help you get in contact with a Merc dealer to handle your warranty work.
Forum: General Q & A
04-24-2008, 10:12 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

Like CAL MAN stated, the ECM does not know. I am...

Like CAL MAN stated, the ECM does not know. I am using a CARTECH FMU to regulate fuel pressure under boost.
Forum: General Q & A
04-23-2008, 01:29 PM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

Can I run without the procharger (belt off) and...

Can I run without the procharger (belt off) and remove the tube after the procharger before the intercooler or is that a bad idea?
Forum: General Q & A
04-21-2008, 10:07 PM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I spoke to Mark at Precision Marine today. He...

I spoke to Mark at Precision Marine today. He told me they do not remove retard timing under boost. Mark also mentioned running a projected tip plug( bought and installed stock gap .040) Thank you...
Forum: General Q & A
04-20-2008, 08:46 PM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

I have the Brodix Race Rite BB-R heads, I do not...

I have the Brodix Race Rite BB-R heads, I do not know which valve springs I have. I will give Competition Products a call on Monday to verify which springs. I looked at my paperwork and it does not...
Forum: Do It Yourself, Boating on a Budget
04-19-2008, 10:49 AM
Replies: 3
Views: 4,553
Posted By Warlock28SXT

On my last boat I used 2"X2" angled aluminum...

On my last boat I used 2"X2" angled aluminum about 4 foot long. If you use a shorter piece you may not get the bottom as level as you want. You may also put more low spots in. Take your time and keep...
Forum: General Boating Discussion
04-19-2008, 10:24 AM
Replies: 12
Views: 1,774
Posted By Warlock28SXT

You can also "drive" through that situation, as...

You can also "drive" through that situation, as the boat rolls to the left you can steer to the right a little and vise versa. When you make a turn in a v-bottom say to the right the boat lays over...
Forum: General Q & A
04-19-2008, 10:14 AM
Replies: 105
Views: 31,149
Posted By Warlock28SXT

It seems the harder I run the boat the richer it...

It seems the harder I run the boat the richer it gets. IT seems that when its looking for more air it cant get it. I tried to run the boat (@ slower speeds) with the hatch open. The AFR leaned out to...
Showing results 51 to 75 of 86
 
Page 3 of 4
1
2
3
4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.