Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 17
1
2
3
11
Last »
Search: Posts Made By: mr3dman
Showing results 1 to 25 of 406
Search took 0.09 seconds; generated 44 minute(s) ago.
Forum: Do It Yourself, Boating on a Budget
03-18-2014, 12:19 PM
Replies: 6
Views: 1,377
Posted By mr3dman

you can't use that straight... need to plumb in a...

you can't use that straight... need to plumb in a cooler with that setup.. I personally haven't used that one tho
Forum: Do It Yourself, Boating on a Budget
03-06-2014, 10:26 AM
Replies: 4
Views: 1,642
Posted By mr3dman

they are magnetic drive pumps... Only 2 or 3...

they are magnetic drive pumps... Only 2 or 3 things can go wrong with them.. Impeller clogged/ cracked, shaft bearings went bad or the windings fried.. You can take it apart to see if it is the first...
Forum: General Q & A
02-19-2014, 01:59 PM
Replies: 5
Views: 656
Posted By mr3dman

I am in a cruiser these days and mud is common...

I am in a cruiser these days and mud is common where I boat.. I got sick of worrying about clogging the drive pickup and switched to a transom mounted water pickup for the engine. Drive halo and...
Forum: General Q & A
02-19-2014, 01:49 PM
Replies: 5
Views: 656
Posted By mr3dman

are u in shallow or muddy water?

are u in shallow or muddy water?
Forum: General Q & A
02-19-2014, 12:52 PM
Replies: 5
Views: 656
Posted By mr3dman

you are real limited in that size boat because...

you are real limited in that size boat because the strainers need to be just below the water level. If you don't have room in front of the motor you are pretty much screwed imho
Forum: Do It Yourself, Boating on a Budget
12-10-2013, 02:54 PM
Replies: 128
Views: 79,462
Posted By mr3dman

any news? you give up or have a success story to...

any news? you give up or have a success story to tell?
Forum: Wanted
09-30-2013, 01:07 PM
Replies: 0
Views: 847
Posted By mr3dman

413-850478 or GM#12551622 cam needed

413-850478 or GM#12551622 cam needed....


thanks,

Tim
Forum: Do It Yourself, Boating on a Budget
06-18-2013, 03:16 PM
Replies: 12
Views: 3,400
Posted By mr3dman

+1

+1
Forum: General Q & A
06-12-2013, 08:10 AM
Replies: 7
Views: 778
Posted By mr3dman

if you do end up needing to drill it out, use a...

if you do end up needing to drill it out, use a pneumatic drill
Forum: Classic Offshore
06-11-2013, 10:32 AM
Replies: 37
Views: 14,193
Posted By mr3dman

F_inscreenname, you are my hero man. So well said

F_inscreenname, you are my hero man. So well said
Forum: Beware and Stolen
06-11-2013, 08:37 AM
Replies: 24
Views: 9,944
Posted By mr3dman

I agree. So many people get burned by not doing...

I agree. So many people get burned by not doing the simplest due diligence. You are spending thousands of dollars on something but won't spend a few dollars to either check the item out yourself or...
Forum: General Q & A
06-05-2013, 02:28 PM
Replies: 14
Views: 9,199
Posted By mr3dman

that's what she said

that's what she said
Forum: General Q & A
06-03-2013, 08:16 AM
Replies: 1
Views: 637
Posted By mr3dman

Solenoid on the top of the motor. Depending on...

Solenoid on the top of the motor. Depending on the engine, it is under the 50 amp breaker, or near it
Forum: General Q & A
05-30-2013, 09:58 AM
Replies: 3
Views: 2,167
Posted By mr3dman

The radio shack one is probably wired 12v...

The radio shack one is probably wired 12v constant (red) ground(blk) and voltage sensing(blue) to activate the buzzer. You cand wire the red and blue to the purple wire and blk to the tan and be...
Forum: Do It Yourself, Boating on a Budget
05-30-2013, 08:35 AM
Replies: 2
Views: 2,257
Posted By mr3dman

If you do have a hanging valve with a piece of...

If you do have a hanging valve with a piece of something as the cause, it is safe to say that piece of whatever is embedded now that you hammered it in place. Head pull is in order imo
Forum: General Q & A
05-30-2013, 08:32 AM
Replies: 3
Views: 612
Posted By mr3dman

Also, check the starter cable. Sounds like you...

Also, check the starter cable. Sounds like you have multiple loose connections roaming around your engine room. Check the block grounds, everything. Loose connections= High resistance and melted wires
Forum: General Q & A
05-23-2013, 12:34 PM
Replies: 49
Views: 6,176
Posted By mr3dman

Personally, you have enough evidence there to...

Personally, you have enough evidence there to assume you will have issues with any other valves your mechanic replaced. I would at this point do some cheap insurance and replace all the valves with...
Forum: General Q & A
05-21-2013, 09:15 AM
Replies: 9
Views: 1,309
Posted By mr3dman

short answer is yes, there is that much oil...

short answer is yes, there is that much oil hanging out in your engine. I fear you losing another engine to some other problem though... You went really overboard on this one imo...
Forum: Swap Shop
05-21-2013, 08:36 AM
Replies: 5
Views: 864
Posted By mr3dman

pics and price to [email protected] plz

pics and price to [email protected] plz
Forum: Swap Shop
05-15-2013, 01:32 PM
Replies: 12
Views: 3,134
Posted By mr3dman

long story short on these heads, he bought a...

long story short on these heads, he bought a boat with a injected 509 in it that needed a refresh. He had the motor taken apart for a rebuild. He then found a drop in complete motor and is parting...
Forum: General Q & A
05-15-2013, 01:21 PM
Replies: 6
Views: 1,399
Posted By mr3dman

LMAO!! Perfect

LMAO!! Perfect
Forum: Do It Yourself, Boating on a Budget
05-14-2013, 03:09 PM
Replies: 36
Views: 8,846
Posted By mr3dman

you are going to have to check your block heat...

you are going to have to check your block heat exchanger and oil cooler to see if there are pieces of the impeller blocking the raw water cooling. It doesn't sound like a Tstat prob
Forum: General Q & A
05-13-2013, 03:43 PM
Replies: 9
Views: 698
Posted By mr3dman

If you flip flopped the blue/ green wires and it...

If you flip flopped the blue/ green wires and it works when you hit the switch UP position, the tab should be going down now. You have a bad solenoid
Forum: General Q & A
05-13-2013, 03:03 PM
Replies: 15
Views: 2,784
Posted By mr3dman

What was it?

What was it?
Forum: General Q & A
05-09-2013, 11:00 AM
Replies: 13
Views: 8,936
Posted By mr3dman

Nice use of the r/c tygon fuel tubing too lol

Nice use of the r/c tygon fuel tubing too lol
Showing results 1 to 25 of 406
 
Page 1 of 17
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.