I was just cleaning up the bell housing and engine coupler, getting ready to install the engines after a rebuild... I noticed that one coupler's splines are sharp teeth rather than the nice square edges... I am going to be looking for one.. Can't afford new... The engine rebuilds are draining me...
I have the Famous... Bravo 1 drives.. around the 1988 Vintage.
Would a coupler from a bravo 2 fit a Bravo 1 drive?
Thanks much....
Quikdecision.

Well, if in doubt I would find the $$ to get a new one. If you bolt everything up and you blow the coupler it's going to cost a lot more. Don't know about the Bravo 2 coupler. You can compare the part numbers here......

http://www.mercruiserparts.com/

Ive got 2 good ones that will work if youre not using the through prop bullhorns. They are the early style made from aluminum plate. In very good shape. rogue2800 at Hotmail.com

Yes They Will Work Only Diiff Between Bravo One And Two Are In The Lowers

Thanks you guys, for the help....
Much appreciated... This site is Awesome...

try ebay

I have a used one from a HP500 with 90 hours for $100

Shawn