Shift Cable End On Keikafer Control Box
09-24-2002 | 09:07 AM
#1
Thread Starter
Registered
Joined: Mar 2001
Posts: 1,239
Likes: 113
From: Oakville,ON
Shift Cable End On Kiekafer Control Box
How do you disconnect the shift cable end from the shift lever, without removing and dissasembling the control box? These are red Morse cables and dual zero effort throttle/shift controls.
It looks pretty tight up in there.
It looks pretty tight up in there.
Last edited by floatingphil; 09-24-2002 at 10:40 AM.
09-24-2002 | 01:43 PM
#2
GOT MERC?
Joined: Aug 2001
Posts: 574
Likes: 0
From: Boynton Beach FL
Sutphil,
You have to remove a rod that runs the length of the control
box. The only way to do this is to remove it from the console
or dashboard. Once you remove the rod then the hook on the
other end of the cable will slip off it's pin.
You have to remove a rod that runs the length of the control
box. The only way to do this is to remove it from the console
or dashboard. Once you remove the rod then the hook on the
other end of the cable will slip off it's pin.
Thread
Thread Starter
Forum
Replies
Last Post
DrFeelgood
Drives and Lower Units
5
11-05-2007 09:42 AM
