Mounting power steering pump.

Reply Subscribe

Thread Tools

03-18-2023 | 12:08 PM

#11

DrFeelgood

Registered

Joined: Aug 2007

Posts: 1,422

Likes: 1,062

From: Orlando, FL

Quote:

Originally Posted by Peter Oberg84

why does some have 2 pumps? I only have one on starboard engine that serves both drives.

It's for redundancy if you lose your Stbd motor and have to come in on Port only.

03-20-2023 | 01:02 PM

#12

cheech

Registered

Joined: Aug 2010

Posts: 1,384

Likes: 565

Dan, Jones is big in circle track world.
https://www.jonesracingproducts.com/

They offer these, most around $100ish or less with a quick Google.
Maybe you could get one of these to suit your situation.

03-20-2023 | 01:08 PM

#13

BBYSTWY

VIP Member

Joined: Jul 2017

Posts: 1,740

Likes: 298

From: Sodus MI

Shoulda switched over to serpentine belts and you could run stock 500 efi stuff

03-20-2023 | 01:23 PM

#14

cheech

Registered

Joined: Aug 2010

Posts: 1,384

Likes: 565

Quote:

Originally Posted by ICDEDPPL

my pump is on the drivers side ....

this would do it but not available https://www.summitracing.com/parts/jrp-psh-8001-bb

Glared over this.

Call these guys or Speedway motors maybe.
Behrents website doesn't say in stock or not.
https://behrents.com/

03-20-2023 | 07:24 PM

#15

ICDEDPPL

Thread Starter

Registered

Joined: Jun 2009

Posts: 9,980

Likes: 6,477

From: Chicago

Quote:

Originally Posted by cheech

Glared over this.

Call these guys or Speedway motors maybe.
Behrents website doesn't say in stock or not.
https://behrents.com/

That`s funny , I found all the same stuff.
I actually have a real paper Jones catalog ! wo hoo

03-22-2023 | 12:13 PM

#16

zz28zz

Registered

Joined: Feb 2013

Posts: 1,461

Likes: 391

Quote:

Originally Posted by underpsi68

A lot of people are using factory car pumps. You just need a controller to make sure they put out the right pressure. There is a company that sells the controllers now.

I remember a while back someone mentioned this (for GM Saginaw pumps) and the only mod needed was to increase the output fitting orifice size to provide adequate flow at lower RPM's (idle). Just need the right size drill bit.