Mounting power steering pump.

Reply Subscribe

Thread Tools

03-18-2023, 12:08 PM

#11

DrFeelgood

Registered

Join Date: Aug 2007

Location: Merritt Island, FL

Posts: 1,302

Likes: 716

Received 971 Likes on 441 Posts

Quote:

Originally Posted by Peter Oberg84

why does some have 2 pumps? I only have one on starboard engine that serves both drives.

It's for redundancy if you lose your Stbd motor and have to come in on Port only.

The following 2 users liked this post by DrFeelgood:

cheech (03-20-2023), PQ290Enticer (03-18-2023)

03-20-2023, 01:02 PM

#12

cheech

Registered

Join Date: Aug 2010

Posts: 1,308

Likes: 814

Received 516 Likes on 306 Posts

Dan, Jones is big in circle track world.
https://www.jonesracingproducts.com/

They offer these, most around $100ish or less with a quick Google.
Maybe you could get one of these to suit your situation.

03-20-2023, 01:08 PM

#13

BBYSTWY

VIP Member

VIP Member

Join Date: Jul 2017

Location: Sodus MI

Posts: 1,658

Likes: 172

Received 254 Likes on 128 Posts

Shoulda switched over to serpentine belts and you could run stock 500 efi stuff

03-20-2023, 01:23 PM

#14

cheech

Registered

Join Date: Aug 2010

Posts: 1,308

Likes: 814

Received 516 Likes on 306 Posts

Quote:

Originally Posted by ICDEDPPL

my pump is on the drivers side ....

this would do it but not available https://www.summitracing.com/parts/jrp-psh-8001-bb

Glared over this.

Call these guys or Speedway motors maybe.
Behrents website doesn't say in stock or not.
https://behrents.com/

03-20-2023, 07:24 PM

#15

ICDEDPPL

Registered

Thread Starter

iTrader: (1)

Join Date: Jun 2009

Location: Chicago

Posts: 8,753

Likes: 1,808

Received 4,374 Likes on 1,250 Posts

Quote:

Originally Posted by cheech

Glared over this.

Call these guys or Speedway motors maybe.
Behrents website doesn't say in stock or not.
https://behrents.com/

That`s funny , I found all the same stuff.
I actually have a real paper Jones catalog ! wo hoo

03-22-2023, 12:13 PM

#16

zz28zz

Registered

Join Date: Feb 2013

Posts: 1,296

Likes: 244

Received 288 Likes on 178 Posts

Quote:

Originally Posted by underpsi68

A lot of people are using factory car pumps. You just need a controller to make sure they put out the right pressure. There is a company that sells the controllers now.

I remember a while back someone mentioned this (for GM Saginaw pumps) and the only mod needed was to increase the output fitting orifice size to provide adequate flow at lower RPM's (idle). Just need the right size drill bit.