Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: JaayTeee
Showing results 1 to 25 of 500
Search took 0.07 seconds.
Forum: General Boating Discussion
05-21-2026, 05:51 AM
Replies: 4
Views: 448
Posted By JaayTeee

Bill’s a very good friend of mine and very...

Bill’s a very good friend of mine and very deserving of this.
Forum: General Boating Discussion
05-11-2026, 05:22 AM
Replies: 22
Views: 10,175
Posted By JaayTeee

This happened 20+ years ago

This happened 20+ years ago
Forum: Drives and Lower Units
05-10-2026, 10:56 AM
Replies: 6
Views: 297
Posted By JaayTeee

If it’s a. 2:1 B2, putting a B1 lower on it...

If it’s a. 2:1 B2, putting a B1 lower on it will give its 1.5 gearing
Forum: Drives and Lower Units
05-04-2026, 05:03 AM
Replies: 6
Views: 318
Posted By JaayTeee

The only time I’ve seen XR’s not have issues...

The only time I’ve seen XR’s not have issues one way or another is under 499 hp;)
Forum: Drives and Lower Units
05-03-2026, 08:10 PM
Replies: 6
Views: 318
Posted By JaayTeee

They stack 2 of those seals together, the one on...

They stack 2 of those seals together, the one on the outside is a redundant seal more or less.
Forum: General Boating Discussion
03-28-2026, 08:01 AM
Replies: 63
Views: 4,544
Posted By JaayTeee

In regards to the motor mounting. I thinking...

In regards to the motor mounting.

I thinking you may want to add something to the bottom of the motor for side load support, much link the gimbal ring flanges on an Alpha/Bravo drive are used for
Forum: General Boating Discussion
03-12-2026, 05:39 AM
Replies: 199
Views: 25,155
Posted By JaayTeee

Present, Been here every day since 11/2002 ...

Present,

Been here every day since 11/2002

Sold the boat in 2017 after it looked like youth sports was going to consume most of our free time.

Been thru 7 years of travel hockey basically...
Forum: Drives and Lower Units
02-22-2026, 07:53 PM
Replies: 5
Views: 621
Posted By JaayTeee

And the NXT

And the NXT
Forum: Cigarette
02-20-2026, 04:43 PM
Replies: 13
Views: 5,812
Posted By JaayTeee

you can use the shaft for an IMCO box ( which...

you can use the shaft for an IMCO box ( which uses the Merc coupler)but you have have the box set at the lowest position ( top holes in the box)

you’ll have to remove the side cover to see where...
Forum: General Boating Discussion
02-03-2026, 11:11 AM
Replies: 13
Views: 1,659
Posted By JaayTeee

The picture looks like it has sloped back drives...

The picture looks like it has sloped back drives so those have been replaced
Forum: General Boating Discussion
02-02-2026, 05:24 AM
Replies: 51
Views: 8,357
Posted By JaayTeee

An OB catamaran or a PWC come to mind….if not...

An OB catamaran or a PWC come to mind….if not that, a surf boat or 3 log pontoon, that seems to be what sells;)
Forum: Baja
01-20-2026, 01:42 PM
Replies: 29
Views: 5,768
Posted By JaayTeee

I’ve been in a stepped tiger that would on smooth...

I’ve been in a stepped tiger that would on smooth water, not sure if it was the boat or the driver

Also drove a 30 eliminator w 500 efi’s that would if over trimmed, it actually yawed around…..it...
Forum: Baja
01-18-2026, 09:24 AM
Replies: 29
Views: 5,768
Posted By JaayTeee

Baja was a leading producer of performance boats...

Baja was a leading producer of performance boats often sold to 1st time users,
now add something that(if operated incorrectly)
can spin out in turns, you’ll (Baja)spend a lot of time in the...
Forum: Baja
01-18-2026, 01:05 AM
Replies: 29
Views: 5,768
Posted By JaayTeee

I had a picture sent to me back when Brunswick...

I had a picture sent to me back when Brunswick gave Baja to Reggie back around 08/09 and they had a 40 OL deck mocked up on top of 42 fountain hull, it had about a 2’ gap between them to get the...
Forum: General Q & A
01-16-2026, 05:08 PM
Replies: 9
Views: 798
Posted By JaayTeee

Mine were Isky Going off the sheet ...

Mine were Isky

Going off the sheet

Grind GR-762-IN
GR-764-EX

int dur 282
ex dur. 290
Forum: General Boating Discussion
12-06-2025, 07:42 AM
Replies: 13
Views: 2,315
Posted By JaayTeee

Just viewing the classifieds here, there’s more...

Just viewing the classifieds here, there’s more center consoles listed than
x cats

There’s only a couple less inboard and non X cats than X cats
Forum: Baja
11-15-2025, 10:56 AM
Replies: 145
Views: 36,016
Posted By JaayTeee

When I use to run the boat @LOTO in the Shootout,...

When I use to run the boat @LOTO in the Shootout, I would take everything out of the cabin, one thing that weighs a lot is the big panel that the v berth that the cushions go over and that covers...
Forum: Baja
11-15-2025, 06:09 AM
Replies: 145
Views: 36,016
Posted By JaayTeee

When I ran them out, the props were more prone to...

When I ran them out, the props were more prone to break free right after it rolled over getting on plane, it also seem to have rapid, slight hop at the trim position I would run it at turning in
...
Forum: Baja
11-13-2025, 11:21 PM
Replies: 145
Views: 36,016
Posted By JaayTeee

I would put 380 k plane bottom plates on it,...

I would put 380 k plane bottom plates on it, switch the lowers to turn in
and I would probably go with 5 blades, and jack them up higher, but that’s just me
Forum: General Q & A
10-13-2025, 04:59 PM
Replies: 10
Views: 839
Posted By JaayTeee

Like speedy says, down low in front…. the 575’s...

Like speedy says, down
low in front…. the 575’s in your cig had them on the same location
Forum: Restorations & Upgrades
10-11-2025, 12:19 PM
Replies: 26
Views: 3,415
Posted By JaayTeee

mercruiserparts.com there’s a section. All...

mercruiserparts.com

there’s a section. All else, the manuals are in there
Forum: Restorations & Upgrades
10-09-2025, 05:28 AM
Replies: 26
Views: 3,415
Posted By JaayTeee

It’s a 6 The skeg has been modified, but by...

It’s a 6

The skeg has been modified, but by the looks of it, I’m guessing it’s a wet
sum

They don’t have any shifting provisions in them,
Forum: General Boating Discussion
10-07-2025, 04:43 PM
Replies: 15
Views: 1,998
Posted By JaayTeee

Thats the thing…..nothing was correct. I...

Thats the thing…..nothing was correct.

I kept waiting for them saying something about spin outs since some of these
mentioned have done that, but no, they mention porpoising, most of these boats...
Forum: General Boating Discussion
10-06-2025, 11:07 PM
Replies: 15
Views: 1,998
Posted By JaayTeee

Top 10 most dangerous speed boats/ youtube

I can’t get the link to work but
check out

TOP 10 Most Dangerous
SPEEDBOATS Ever Built. on YouTube

You’ll be thinking WTF after every review

You think our Main Street media has...
Forum: Drives and Lower Units
09-30-2025, 05:39 AM
Replies: 3
Views: 833
Posted By JaayTeee

It’s most likely the shift cam rubbing on the...

It’s most likely the shift cam rubbing on the high spot of the lower driven gear bump ring.

Once it’s running and it goes through the normal shift process where the bump ring ( via the shift...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.