Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
Search: Posts Made By: jennys express
Showing results 1 to 10 of 10
Search took 0.00 seconds.
10-07-2009, 10:19 PM
Replies: 5
Views: 2,282
Posted By jennys express

check shift cable behind bell housing where drive...

check shift cable behind bell housing where drive mounts and make sure its tight and not full of rust
10-07-2009, 10:15 PM
Replies: 11
Views: 5,054
Posted By jennys express

what type of exhaust does it have could be...

what type of exhaust does it have could be leaking from bull horns at bottom of engine?
09-30-2009, 02:06 PM
Replies: 100
Views: 49,045
Posted By jennys express

The boat turn out to my expections i wanted the...

The boat turn out to my expections i wanted the best for Dr. Bob and he got it good luck with your beautiful boat Dr Bob
05-15-2009, 09:32 AM
Replies: 16
Views: 3,471
Posted By jennys express

use anything but royal purple merc has tested...

use anything but royal purple merc has tested thaqt stuff and is bad ist hand knowlege here todd
05-03-2009, 11:29 PM
Replies: 5
Views: 2,819
Posted By jennys express

i have a new set of older gears never run but no...

i have a new set of older gears never run but no clutch cone i think there 1.5s i pull a bearing out of the middle of gear it had a dent in bearing it can be relaced
05-03-2009, 11:24 PM
Replies: 13
Views: 2,037
Posted By jennys express

mark the propshaft 1time all the way round and...

mark the propshaft 1time all the way round and the u joint spins 1 and a half its a 1.5 ratio
05-03-2009, 05:48 PM
Replies: 2
Views: 1,546
Posted By jennys express

check the gimbal u have to pull the drive to do...

check the gimbal u have to pull the drive to do so or if boat is out of water run engine on flush and turn steering side to side and listen for a growl in the gimbal area todd
05-02-2009, 04:31 PM
Replies: 10
Views: 4,170
Posted By jennys express

exhaust bullhorns

exhaust bullhorns
05-02-2009, 04:23 PM
Replies: 7
Views: 1,484
Posted By jennys express

i have an older gearset ill look monday and see...

i have an older gearset ill look monday and see which one it is i took out top bearing because it had a dent in it u can replace them the gears r new never use todd
05-02-2009, 04:18 PM
Replies: 53
Views: 10,825
Posted By jennys express

rebuild the rams about 100.00 each in parts you...

rebuild the rams about 100.00 each in parts you will have to press off end caps and sand shafts with 1000 sandpaper or red scothbrite pad. todd
Showing results 1 to 10 of 10


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.