the bearing and race are a set so i am re using the outer race found in the old housing
and pressing it in the new housing.
Notice how it is pinned to prevent rotation at 26000 rpm.

if you need any help with the safety wire i have a couple of tricks i can show you

Yes i need all the help i can get my fingers are bleeding.

Here is the two pinch plates side by side they sit in between the bearing housing and the seal
retainer.
There is little holes at the points that spray oil at the bearing beneath and above.

if you observe some smoke in the exhaust.
Sometimes it will smoke out the stack even after shutdown.
Here is the problem look closely at the center of the rotor
you can see the burnt oil.

we are going after #9

we need to remove the exhaust diffuser.
remove 3-4 bearing oil feed and scavenge tubes

remove the two countersunk Phillips screws

install puller

should look like this now

remove the pt spanner nut
remove rear impeller and washer
items17,18 19 20 21 22
Go get more beer before liquor store closes
call somebody that cares