oil feed and scavenge tubes reinstalled

drop diffuser Assembly down on top of exhaust diffuser.

place down your 2nd pt nozzle taking notice on your shims and three alignment pins
drop on your first pt rotor remember we numbered the bolts so they may go back in the same
place. Dont forget to line up the marks

torque them down to 160inch lbs
dont forget to bend the locking tabs

I have placed 4 1st turbine nozzle bolts to hold the assemblie together while i torque the rotor bolts
i remove them now and install the 1st pt 703 nozzle.

i applied nickel ease to all the bolts and bring them too 40 inch lbs.
Now turn down the shop stereo and spin the rotor to listen for rubs.

drop com buster liner back in
tighten up these nuts to 30inch lbsand peen over the new locking tabs

install fire shield

fuel atomizers are back from flow testing
two were bad