Move down here, can get beer anywhere, anytime! Great thread! Thanks

Then we would really get Sh@t done..
Alcohol the cause of problems yet the cure.
install the hollow bolt protector

install puller base and install puller
what should happen here is it should push the 2nd pt rotor out of the bearing housing.

it was so cold i had to keep that blanket on it to keep it warm
it looks like this now

here is the bearing housing. take a look at it it is clearly evident tha it was leaking
by the coking deposits.

here is the flip side
it obviously presses out from this side.

here it is new seal installed

i know my saftey wiring looks like i got turrets

Pt reassembly
drop exhaust diffuser back on

The center spanner nut was torqued to 250ft lbs
dont forget to peen over the stop washer.
i used three12 point bolts to pull in the diffuser first before i tightened the counter sunk Phillips screws