Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 7
1
2
3
Last »
Search: Posts Made By: Couginitnordic
Showing results 1 to 25 of 158
Search took 0.01 seconds.
Forum: Nordic
10-18-2016, 09:12 AM
Replies: 9
Views: 2,029
Posted By Couginitnordic

My 425hp 496 rage will do 75 with a 26P so I...

My 425hp 496 rage will do 75 with a 26P so I would say something is wrong. Are you on the rev limiter?
Forum: Nordic
10-15-2016, 09:28 AM
Replies: 9
Views: 2,029
Posted By Couginitnordic

I would try a 4 blade 28P on that.

I would try a 4 blade 28P on that.
Forum: General Boating Discussion
08-27-2016, 10:17 AM
Replies: 50
Views: 7,019
Posted By Couginitnordic

Went from a 2000 Baja 212 Islander used to a 2010...

Went from a 2000 Baja 212 Islander used to a 2010 Nordic 25 Rage bought new.
Forum: Nordic
08-12-2016, 09:20 AM
Replies: 18
Views: 7,633
Posted By Couginitnordic

Mine is a 2010 that has the newer materials and...

Mine is a 2010 that has the newer materials and design. Single belly gas tank with fuel filler on one side with fiberglass floor liner and snap in carpet. Battery trays are in engine compartment...
Forum: Nordic
08-12-2016, 09:17 AM
Replies: 18
Views: 7,633
Posted By Couginitnordic

I have a rage MCOB. Tubing no problem and water...

I have a rage MCOB. Tubing no problem and water skiing isn't bad. I can keep the Rage on plane all the way down to 2000RPM about 20mph-24mph if it's not too loaded down with people. The rage is...
Forum: General Q & A
08-07-2016, 11:34 AM
Replies: 12
Views: 7,997
Posted By Couginitnordic

I too had the two beep alarm last week. Engine...

I too had the two beep alarm last week. Engine ran fine but when I looked at the IAC it had melted plastic on the connector. Replaced it with new IAC and gasket all is good now.
Forum: Nordic
07-09-2016, 09:50 AM
Replies: 6
Views: 1,644
Posted By Couginitnordic

I have been looking at Formulas to add to the...

I have been looking at Formulas to add to the fleet. Maybe I could just tow the rage with the 40SS. Use the rage as a tender. Best of both worlds.
Forum: Nordic
06-28-2016, 11:14 AM
Replies: 27
Views: 3,704
Posted By Couginitnordic

It was a terrible feeling...I couldn't sleep that...

It was a terrible feeling...I couldn't sleep that night. It was the first scratch on her since she left the factory. My buddy looked at it and was like it's not that bad, but I could tell from the...
Forum: Nordic
06-27-2016, 09:05 AM
Replies: 27
Views: 3,704
Posted By Couginitnordic

Finally put the Rage back in the water this last...

Finally put the Rage back in the water this last week. I have been too busy with a remodel to boat. First time out I hit my dock when coming in...wind blowing and my lift was a little low. Left...
Forum: General Boating Discussion
05-19-2016, 06:15 PM
Replies: 13
Views: 13,676
Posted By Couginitnordic

I tapered the end and cut my added step at the...

I tapered the end and cut my added step at the opposite angle so it matched up with the hull. I used trex for my steps then through bolted and carpeted.
Forum: General Q & A
10-22-2015, 09:40 PM
Replies: 9
Views: 877
Posted By Couginitnordic

+3 just add to the existing bunks.

+3 just add to the existing bunks.
Forum: Drives and Lower Units
09-04-2015, 07:43 PM
Replies: 36
Views: 9,669
Posted By Couginitnordic

I use the Amsoil severe gear in mine since my...

I use the Amsoil severe gear in mine since my second oil change. No problems so far. I bought it new in 2012. I use the Redline Heavy Duty Shockproof in my track car. Transmission and diff. It's...
Forum: General Boating Discussion
09-03-2015, 09:36 AM
Replies: 18
Views: 2,364
Posted By Couginitnordic

I just say sorry I don't make the rules I just...

I just say sorry I don't make the rules I just enforce them. That way I can't be blamed.😀
Forum: General Boating Discussion
08-30-2015, 09:16 AM
Replies: 7
Views: 630
Posted By Couginitnordic

Go to the Nordic factory at Havasu. Call and ask...

Go to the Nordic factory at Havasu. Call and ask for Mike Chandler.
Forum: General Boating Discussion
08-23-2015, 10:18 AM
Replies: 46
Views: 10,655
Posted By Couginitnordic

This was in Portland. OCM= Oregon Custom Marine

This was in Portland. OCM= Oregon Custom Marine
Forum: General Boating Discussion
08-23-2015, 10:14 AM
Replies: 9
Views: 1,510
Posted By Couginitnordic

I actually watched someone do the same thing at...

I actually watched someone do the same thing at the launch a few years ago. Unfortunately my boat was hit by a girl that freaked out at the controls and launched her boat into the back of my Baja. ...
Forum: General Boating Discussion
08-22-2015, 11:44 AM
Replies: 46
Views: 10,655
Posted By Couginitnordic

Tim is shady. I know too many people that have...

Tim is shady. I know too many people that have not had savory dealings with him. When he was just in Oregon the deals where getting shady then he moved....my guess is he was feeling heat then. ...
Forum: Beware and Stolen
06-16-2015, 05:58 PM
Replies: 52
Views: 26,489
Posted By Couginitnordic

I am going to call Chris about this....He is a...

I am going to call Chris about this....He is a fraternity brother of mine from college. Dealing with Tim makes me nervous from some of the dealings I have heard of. Almost bought a boat from him 3...
Forum: General Boating Discussion
06-07-2015, 10:10 AM
Replies: 18
Views: 5,758
Posted By Couginitnordic

I did my dock with Trex a few years ago. Has...

I did my dock with Trex a few years ago. Has held up perfect but it does get hot sometimes so your sprinkler install will work great. Nice job!
Forum: Nordic
06-07-2015, 10:06 AM
Replies: 21
Views: 6,246
Posted By Couginitnordic

Ok guys I put on the stock 28p bravo and have...

Ok guys I put on the stock 28p bravo and have been running it a couple of days now. Here is what I think. Slower out of hole but not bad if the boat only has a couple of people. Love the mid range...
Forum: Nordic
05-07-2015, 08:58 AM
Replies: 1
Views: 856
Posted By Couginitnordic

Wind deflector installation

I got my new Nordic wind deflectors and now I have to install them. I see they mount under the windshield. Any advise on drilling the holes in the windshield? This is making my butt pucker.
Forum: Nordic
04-07-2015, 07:50 AM
Replies: 18
Views: 4,626
Posted By Couginitnordic

I agree with the cleat statement. That is the...

I agree with the cleat statement. That is the one ***** I have about Nordic boats is the cleat placement. Almost worthless.
Forum: Drives and Lower Units
04-06-2015, 11:47 AM
Replies: 4
Views: 1,142
Posted By Couginitnordic

Thanks Sydwayz. That's what I was thinking. ...

Thanks Sydwayz. That's what I was thinking. It's kind of like adding a stern jack that land and sea used to sell for bravo drives. My boat has a high X dimension from the factory so I figure it...
Forum: Nordic
04-05-2015, 12:17 PM
Replies: 12
Views: 3,508
Posted By Couginitnordic

Hi Jay did you go through with the vasectomy for...

Hi Jay did you go through with the vasectomy for the motor? I Would give up my 496 and some heavy cash for the motor, but I don't think I would go under the knife for it.
Forum: Drives and Lower Units
04-05-2015, 12:08 PM
Replies: 4
Views: 1,142
Posted By Couginitnordic

I figure that's the way it would have come from...

I figure that's the way it would have come from the factory since my boat is a newer vintage. I don't want to put old technology in a newer boat.
Showing results 1 to 25 of 158
 
Page 1 of 7
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.