Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: Rookie
Showing results 1 to 25 of 500
Search took 0.06 seconds.
Forum: General Q & A
05-24-2026, 10:11 PM
Replies: 5
Views: 236
Posted By Rookie

I run Comp 933's for springs. They are not...

I run Comp 933's for springs. They are not available any longer so here are the specs.

Seat Pressure: 171 lbs @ 1.950"
Open Pressure: 492 lbs @ 1.300"
Spring Rate: 494 lbs/in
Coil Bind...
Forum: General Q & A
05-24-2026, 10:00 PM
Replies: 5
Views: 236
Posted By Rookie

I set lash around 0.007" cold on my HR/solid...

I set lash around 0.007" cold on my HR/solid setups. Been running them for about 15 yrs and my engine has always ran solids on HR. When I told Comp that I was going to run solids on their HR cam the...
Forum: Prop Talk
05-16-2026, 10:17 PM
Replies: 9
Views: 360
Posted By Rookie

I'd try a lower pitch Q4. Hydro's seem to be a...

I'd try a lower pitch Q4. Hydro's seem to be a pitch or 2 higher compared to Bravo's. They always seem to knock the dick off the RPM's when I have ran them.
Have you contacted Doug?
Forum: General Q & A
05-16-2026, 10:11 PM
Replies: 30
Views: 976
Posted By Rookie

I had this issue when I went to Merlin heads...

I had this issue when I went to Merlin heads years ago. Only thing that solved it was using the water passages on the back of the intake. Within 5 minutes of idling and then getting on plane it would...
Forum: General Q & A
05-06-2026, 07:44 PM
Replies: 14
Views: 550
Posted By Rookie

I lost speed adding hydraulic steering on my...

I lost speed adding hydraulic steering on my Panther. It settled the hull down. No more chine walking or porpoising any longer. Loose is fast, but not good in your steering.
Forum: Wanted
04-28-2026, 08:43 PM
Replies: 27
Views: 1,940
Posted By Rookie

https://youtu.be/oBPDpV1cXWw?si=7hCAG5uhRb2LzCI5

https://youtu.be/oBPDpV1cXWw?si=7hCAG5uhRb2LzCI5
Forum: Wanted
04-23-2026, 08:22 PM
Replies: 9
Views: 1,438
Posted By Rookie

I still have 2 sets of 4" ...

I still have 2 sets of 4"
https://www.offshoreonly.com/forums/swap-shop/387106-mufflers-5-4-5-4-a.html
Forum: General Q & A
04-12-2026, 07:59 PM
Replies: 198
Views: 147,852
Posted By Rookie

Standard HP4 is what I would use. We ran the HP6...

Standard HP4 is what I would use. We ran the HP6 on the race boat, but for a recreation boat I would just run the HP4. They are readily available anywhere. You never know when you might need to...
Forum: General Q & A
03-31-2026, 07:36 PM
Replies: 38
Views: 2,020
Posted By Rookie

Adding a relay and heavier gauge wire made a day...

Adding a relay and heavier gauge wire made a day and night difference on my Panther and AT. I use reversing motor relays. (snowplow relay) A lot simpler. You can find them cheaper....
Forum: Do It Yourself, Boating on a Budget
03-27-2026, 07:46 PM
Replies: 29
Views: 1,964
Posted By Rookie

I don't like the idea of a 632 in your case. Too...

I don't like the idea of a 632 in your case. Too many unknowns.
That's all I got...
Forum: General Q & A
03-24-2026, 07:25 PM
Replies: 59
Views: 7,615
Posted By Rookie

Thanks, What's Splash Zone? Edit... No, I use...

Thanks,
What's Splash Zone?
Edit... No, I use KBS Coating NuMetal Epoxy puddy.
Forum: Wanted
03-20-2026, 07:53 PM
Replies: 9
Views: 727
Posted By Rookie

I have 2 sets ...

I have 2 sets
https://www.offshoreonly.com/forums/swap-shop/387106-mufflers-5-4-5-4-a.html
Forum: General Q & A
03-05-2026, 07:11 PM
Replies: 2
Views: 434
Posted By Rookie

I run my quick fitting inside the transom and the...

I run my quick fitting inside the transom and the just "T" them out the exhaust ring through either one of the 4 screw holes or drill another hole in the ring for the hose to go through. Gives it a...
Forum: Drives and Lower Units
02-22-2026, 08:15 PM
Replies: 1
Views: 436
Posted By Rookie

71c Velvet Transmissions

I have 2-71c transmissions. I believe them to be the 2.75:1 ratio. Looking to sell them but don't know what they would have come out of. I know our type boats utilize the 1:1, but what market should...
Forum: Swap Shop
02-21-2026, 08:52 PM
Replies: 15
Views: 6,102
Posted By Rookie

Original poster hasn't logged on in over 3yrs.

Original poster hasn't logged on in over 3yrs.
Forum: General Q & A
02-21-2026, 08:12 PM
Replies: 5
Views: 547
Posted By Rookie

Exhaust location? I thought it needs to be moved...

Exhaust location? I thought it needs to be moved up and out ~1/2"
Forum: Prop Talk
02-07-2026, 06:45 PM
Replies: 11
Views: 1,629
Posted By Rookie

It's only rated to 4200-4600RPM from Mercury. To...

It's only rated to 4200-4600RPM from Mercury. To make that few HP from a 540 they made it a very conservative build. I believe stamped rockers.
I'd start with your prop to baseline. It's only a...
Forum: General Q & A
02-05-2026, 07:04 PM
Replies: 27
Views: 2,345
Posted By Rookie

I know someone that has been running 2-$150 ebay...

I know someone that has been running 2-$150 ebay pumps with no issues. I keep a spare eBay pump on my shelf for just incase.
Forum: General Boating Discussion
01-22-2026, 07:00 PM
Replies: 24
Views: 2,343
Posted By Rookie

They are not the original pedal assisted electric...

They are not the original pedal assisted electric bikes of the past. They are basically electric motorcycles with pedals. I hate laws, but they morphed into motorcycle territory and need to looked as...
Forum: Classic Offshore
01-21-2026, 06:24 PM
Replies: 7
Views: 1,798
Posted By Rookie

What is the HIN# on the transom above your...

What is the HIN# on the transom above your stepladder in the 4th pic?
Forum: General Q & A
01-10-2026, 12:26 PM
Replies: 11
Views: 924
Posted By Rookie

Sorry, that comment was in regards to intake port...

Sorry, that comment was in regards to intake port CSA.
And I'm referring to collectors as the OP was asking about. Tuning header pipes is a is a different dynamic. But in that regard, I would still...
Forum: General Q & A
01-09-2026, 11:14 PM
Replies: 11
Views: 924
Posted By Rookie

Seriously?... It makes more power throughout...

Seriously?...
It makes more power throughout the power curve.
Forum: General Q & A
01-09-2026, 10:55 PM
Replies: 11
Views: 924
Posted By Rookie

Exactly what I said. Going from 3.8" to 3.0"...

Exactly what I said. Going from 3.8" to 3.0" choking it down. We can get into as much pipe tuning dynamics as we want. I have never seen any dyno or real world application where "backpressure" makes...
Forum: General Q & A
01-09-2026, 07:14 PM
Replies: 11
Views: 924
Posted By Rookie

Choking down the exhaust is never the answer.

Choking down the exhaust is never the answer.
Forum: General Boating Discussion
01-02-2026, 07:19 PM
Replies: 63
Views: 38,760
Posted By Rookie

I don't have a million dollar boat so this...

I don't have a million dollar boat so this doesn't affect me.
Carry on...
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.