Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: racinjason65
Showing results 1 to 25 of 37
Search took 0.01 seconds.
Forum: Prop Talk
05-12-2013, 03:21 PM
Replies: 7
Views: 2,856
Posted By racinjason65

I have a 24 ft HTM with 1,150hp and 1.36 gears, I...

I have a 24 ft HTM with 1,150hp and 1.36 gears, I have several props and currently run Cutting Edge Propellers. With your 1.5 ratio and if you have an honest 1,100 you may run out of prop on a 4...
Forum: Vendor Talk
04-22-2013, 11:26 AM
Replies: 34
Views: 9,570
Posted By racinjason65

I'm going by Cutting Edge today to pick up...

I'm going by Cutting Edge today to pick up another prop for Desert Storm. I've been extreamly happy with both the customer service and the product I've received at Cutting Edge. I've also had BBlades...
Forum: HTM
03-30-2013, 12:47 AM
Replies: 3
Views: 2,879
Posted By racinjason65

I'll measure mine in a couple weeks when I get...

I'll measure mine in a couple weeks when I get back out to Havasu (where I store my boat). I think propping correctly is more important than X dimension. With props I have a lot of control over the...
Forum: HTM
12-31-2012, 12:10 PM
Replies: 33
Views: 17,251
Posted By racinjason65

I think the biggest issue would be moving the...

I think the biggest issue would be moving the engine far enough forward to make room for the trans.
Forum: General Boating Discussion
12-31-2012, 01:26 AM
Replies: 51
Views: 12,956
Posted By racinjason65

I got my HTM insured through Wozencraft with over...

I got my HTM insured through Wozencraft with over 1,000 HP and a stated top speed of 115+... As far as rough water I've been out in the roughest water Havasu has to offer, and I know other HTM owners...
Forum: Eliminator
12-07-2012, 03:17 PM
Replies: 25
Views: 6,228
Posted By racinjason65

My friend used to have a 30 Eagle with twin Merc...

My friend used to have a 30 Eagle with twin Merc 575's and it ran mid 90's. To go in the 80's with a single, you'd need more power than a bravo drive would be reliable with
Forum: HTM
11-13-2012, 08:11 AM
Replies: 10
Views: 9,838
Posted By racinjason65

[QUOTE=stirling;3813510]Jason ,can you give me...

[QUOTE=stirling;3813510]Jason ,can you give me the center propshaft height from your boat ?

Mine is exactly 1 inch under the lowest part of the sponsons with the drive level .

I ran the Bmax...
Forum: HTM
11-11-2012, 11:29 AM
Replies: 10
Views: 9,838
Posted By racinjason65

Depends how big the other boats are, at Desert...

Depends how big the other boats are, at Desert Storm where there are 40-50 foot boats going 180 MPH spinning #6 props and the water is all torn up in both directions it can be a bumpy ride. If you...
Forum: HTM
11-11-2012, 11:24 AM
Replies: 30
Views: 17,771
Posted By racinjason65

I can stay on plane at those speeds (25 mph) in...

I can stay on plane at those speeds (25 mph) in smooth water, put thats slowing down after getting on plane. My boat rolls over onto plane and settles down atbout 40 mph. For putting around 25 -30...
Forum: HTM
11-09-2012, 08:07 AM
Replies: 30
Views: 17,771
Posted By racinjason65

Personally I'd look for one with more power, the...

Personally I'd look for one with more power, the hull doesn't really start to work until 65 MPH. So I'd look for one that can cruise at 65 or above loaded with people and fuel.
Forum: General Boating Discussion
11-09-2012, 12:15 AM
Replies: 10
Views: 1,577
Posted By racinjason65

I have a HTM and use it mostly in Havasu. I run...

I have a HTM and use it mostly in Havasu. I run it in almost any conditions (including following the big boats at Desert Storm) and have been in 2 other HTM's in the ocean. It is the only single...
Forum: Prop Talk
10-31-2012, 10:08 PM
Replies: 7
Views: 1,296
Posted By racinjason65

I have a HTM SR24 cat with a blown 565, I run...

I have a HTM SR24 cat with a blown 565, I run several boost and prop combos depending on the fuel i run. My 6lb boost combo makes about 960 HP and I run 117 MPH with a custom Propellers 29P 4 blade...
Forum: Swap Shop
10-28-2012, 10:23 PM
Replies: 5
Views: 1,658
Posted By racinjason65

does this come with the Arneson hydraulic helm...

does this come with the Arneson hydraulic helm also?
Forum: HTM
10-22-2012, 11:20 PM
Replies: 10
Views: 9,838
Posted By racinjason65

I have a 2002 HTM SR24 with over 1,000 HP Most of...

I have a 2002 HTM SR24 with over 1,000 HP Most of them have great build quality, handle excellent for a cat, and are as safe as any cat in the same size range with equal power. I have had mine 129...
Forum: HTM
09-08-2012, 03:05 AM
Replies: 30
Views: 17,771
Posted By racinjason65

I'll run 7-7.5 lbs of boost on pump gas and run...

I'll run 7-7.5 lbs of boost on pump gas and run 119 mph. But I do my boating in Arizona, where they are adding 10% ethanol on gas at the pump, I try and stay away from that and use 100 octane...
Forum: HTM
07-25-2012, 11:04 PM
Replies: 30
Views: 17,771
Posted By racinjason65

XR with upgraded shafts 1.36 ratio and I have a...

XR with upgraded shafts 1.36 ratio and I have a couple Cutting Edge Propellers that I run depending on how the boat is set up.
Forum: HTM
07-23-2012, 11:11 PM
Replies: 30
Views: 17,771
Posted By racinjason65

127 on gps speedo, 129 on handheld GPS still have...

127 on gps speedo, 129 on handheld GPS still have a little fine tuning to do...
Forum: HTM
07-14-2012, 11:46 AM
Replies: 30
Views: 17,771
Posted By racinjason65

I have a SR24 with 1,050 Hp. I live in Huntington...

I have a SR24 with 1,050 Hp. I live in Huntington Beach and boat in Havasu.
Forum: General Boating Discussion
06-22-2012, 11:58 PM
Replies: 1
Views: 594
Posted By racinjason65

They are mainly a "west coast" boat. Try...

They are mainly a "west coast" boat. Try advertising on one of the forums more geared toward Havasu,Parker, etc. I own one and have seen 4 or 5 HTM's sold in the last year.
Forum: Prop Talk
06-07-2012, 10:45 PM
Replies: 16
Views: 2,347
Posted By racinjason65

Have you tried Cutting Edge Propellers yet? They...

Have you tried Cutting Edge Propellers yet? They cast their own from scratch so they are quite a bit stronger than a modified bravo or maximus. They also have the capability to make a bravo style...
Forum: Prop Talk
06-06-2012, 12:02 AM
Replies: 4
Views: 1,887
Posted By racinjason65

I have a HTM 24 that I used to have the same...

I have a HTM 24 that I used to have the same issue with. I now run custom Cutting Edge Props and now I don't have any prop related issues.

Call Greg Hittner at Cutting Edge Propellers (949)...
Forum: Prop Talk
05-30-2012, 08:44 AM
Replies: 24
Views: 9,441
Posted By racinjason65

For your wiring diagram I'd call Cale at HTM2 in...

For your wiring diagram I'd call Cale at HTM2 in Lake Havasu (928)208-1999. If you are running 24 pitch props 5900 rpm you are most likley not making 750 HP and I wouldnt be putting on blower pulleys...
Forum: Prop Talk
05-15-2012, 10:03 PM
Replies: 3
Views: 2,563
Posted By racinjason65

The simple answer is yes! It makes a huge...

The simple answer is yes! It makes a huge difference! Your last question, about if you need "labbed" props on both drives is the most important. First of all, with twins you MUST have matching...
Forum: Prop Talk
05-14-2012, 03:10 AM
Replies: 24
Views: 9,441
Posted By racinjason65

That's just about exactly what you should be...

That's just about exactly what you should be running. In 2001 Ken Lane was still building all the in house HTM motors and the single carb 565 made 650 Hp. One of my friends has the same motor in a...
Forum: General Boating Discussion
05-11-2012, 02:22 AM
Replies: 4
Views: 1,230
Posted By racinjason65

Redline custom boats in Las Vegas builds a R/T29...

Redline custom boats in Las Vegas builds a R/T29 and RPM (Revolution Performance Marine) in Alabama builds the 26 Redline
Showing results 1 to 25 of 37
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.